570573

Konig Electronic SATFINDER Manual

1
Zoom out
Zoom in
Previous page
1/1
Next page
SATFINDER USER GUIDE
WIRING AND OPERATION:
1. Connect a jumper cable from the LNB to the Satellite Finder’s “TO LNB” input.
2. Connect the “TO REC” to 13-18V DC power which comes from the Satellite Receiver.
3. Make sure the Satellite Finder is properly connected. Plug in the AC cord and turn on the Satellite Receiver. There will be a
Slight reading on the scale of around 1.
4. Make coarse dish adjustments by setting Azimuth and Inclination.
5. Set the reading to around 5 on the Satellite Finder by adjusting the Level Control.
6. Adjust dish position, feedhorn position and polarization to have the highest reading on the finder. If full scale, reduce the
reading by turning the level control counterclockwise.
7. Remove the jump cable and Satellite Finder. Resume connection of Satellite Receiver and LNB.
IMPORTANT:
● When using this unit to install C Band Dish, you must not place the Satellite Finder in front of the dish to avoid always full
scale.
● When using high gain LNB’s, gains of 60dB or higher, Insert a 5dB attenuator in between the LNB and Satellite Finder, or
replace the jump cable with a 20ft RG-59U.
● If the read-out is jumping, the sensitivity is too high. Reduce the sensitivity by adjusting the level control on the Satellite
Finder, or increase the level control by turning it clockwise.
SPECIFICATION:
Frequency Range: 0.95 - 2.25GHz
Gain: 17dB
Sensitivity*: 7
Power Supply: 13-18V DC
Operating Range**: LNB Gain = 52 - 60dB
* Under the following test conditions: LNB Gain = 55dB, three carrier C/N = 15dB
** Insert a 5dB attenuator when operating with LNB Gain = 60 - 65dB
Note: All specifications cited in this leaflet are subject to change without notice


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic SATFINDER at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic SATFINDER in the language / languages: English as an attachment in your email.

The manual is 0,13 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info