626912

Konig Electronic KN-RFRI KIT Manual

2
Zoom out
Zoom in
Previous page
1/20
Next page
ENGLISH
The radio control units included in the packaging are already programmed in bistable
mode and ready to use. To reprogram the remote controls, please follow below steps.
Programming the König receiver or additional remotes:
(To be performed on the receiver, picture 1)
The receiver can be programmed into: monstable or bistable mode
This König remote can be programmed to control output 1 and output 2 of the receiver in
bistable or monostable mode.
Example1: With the monostable mode, you can sent out a pulse to the central unit of an
automatic gate and open it.
Example 2: With the bistable mode, you can switch on a device (like a lamp) by pressing
the button one time, to switch o the device you have to press the same button once
again.
Example 3: If you use the monostable mode with a lamp, you push the button to switch on
the lamp, but when you release this button the lamp switches o.
So, you only should use the monostable mode if you need a pulse, otherwise you have to
use the bistable mode.
STEP 1:
Press the P1 button on the receiver:
1 time to program output 1 in monostable mode.
2 times to program output 2 in monostable mode.
3 times to program output 1 in bistable mode.
4 times to program output 2 in bistable mode.
STEP 2 (perform immediately after step 1 is carried out):
Keep pressing button A or B on the König remote (picture 2) that you want to sync until
the LED on the receiver begins to ash.
Erasing codes
There are two types of erasing.
A: Erasing of an individual code:
Press key P2 for approx. 2 seconds (release the key); the LED will light up, press the key on
the König remote control you would like to delete.
B: Erasing all acquired codes:
Press key P2 until the LED lights up (approx. 8 seconds).
RECEIVER
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic KN-RFRI KIT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic KN-RFRI KIT in the language / languages: All languages as an attachment in your email.

The manual is 0,31 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info