508657

Konig Electronic HC-BM05 Manual

4
Zoom out
Zoom in
Previous page
1/84
Next page
4
HI = full range
LOW = reduced range (for a further reduction in electric smog)
At the highest sensitivity even faint noises are transmitted, and at the lower sensitivity only loud
noises are transmitted.
• It will pick up the baby’s sounds automatically and transmit it to the receiver immediately.
• VOX (Voice Activation) sensitivity can be adjusted by rotating the switch on top of the transmitter.
• The transmitter is only active when sounds can be heard. This function eliminates any
unnecessary electric smog.
• The night light can be switched to ON or OFF manually, or to AUTO if you want to allow the night
light to be activated by VOX (sound). The switch is located at the bottom of the unit.
The receiver (Parent unit)
• Turn on the receiver with the ON/OFF switch at the side of the receiver. The power LED light
should be turned ON.
• Select channel A or B for transmission with the channel switch inside the battery compartment. It
has to be in the same channel as the transmitter.
• Rotate the volume switch until the desired sound level is obtained.
• The 5 LED lights indicate the intensity of the sound received.
Range control
The receiver is equipped with optical range control. If the signal from the transmitter is no longer
adequately received, both red LED’s on the receiver LED light strip will flash.
Note:
When using the system as a baby monitor, make sure that the transmitter is positioned at least
1 metre away from the child. This system is not a substitute for personal supervision of a child
or person in need of care; it is simply intended to provide additional support. No liability
beyond that of the statutory warranty is accepted. This applies in particular to cases where this
system is used for medical applications contrary to its intended use.
TROUBLESHOOTING
Problem Possible Cause – things to do/check
No function Check the power supply.
Is the mains adapter connected correctly?
Are the rechargeable or standard batteries inserted correctly?
Are the rechargeable batteries charged?
No transmission Check the setting of the channel selection switches on both
units. They must be set to the same position.
Move the transmitter closer to the baby (but no nearer than
1 metre away from the child) or increase the microphone
sensitivity.
Move the receiver closer to the transmitter.
Are both units switched on?
Transmission interference Select another transmission/reception channel on both units.
Move the receiver closer to the transmitter.
Check the batteries and replace/recharge them if necessary.
Move the slide switch of the transmitter to HI position for full
range.
… 4 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic HC-BM05 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic HC-BM05 in the language / languages: English, German, Dutch, French, Italian, Swedish, Spanish, Finnish as an attachment in your email.

The manual is 1,32 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info