508613
3
Zoom out
Zoom in
Previous page
1/83
Next page
3
16. REMOTE SENSOR
17. USB SLOT COMPATIBLE To listen to MP3 music files on your USB flash
memory stick
18. TUNING CONTROL Select AM/FM/FM ST. stations
19. BAND SELECTOR (AM · FM · FM · ST.) Select AM/FM/FM ST. wave band
20. BATTERY DOOR To open battery compartment
21. AC MAINS Inlet for power cord
REMOTE CONTROL HANDSET
The functions of the remote control buttons are the same as those of the of CD/MP3/USB/SD section.
Select the MP3/CD tracks using the (+10) / (-10) button.
- The remote control volume button has no function in the radio mode.
Fast-forward or rewind a song
1. Press and hold next/fast-forward
or previous/rewind .
During fast-forward or rewind function, the output will be muted until release.
2. When you recognize the passage you want, release
or .
- Normal playback resumes.
Selecting the folder
- Press and hold the +10/FOL+button or -10/FOL- button for 3 sec, folder number will show the
sequence “F01->F02….”, just release the button when your favourite folder is displayed.
- The display will show the folder number and the song number. Alternately within 5 sec.
POWER SUPPLY
Using AC power
1. Check if the powser voltage, as shown on the type plate located on the bottom of the set,
corresponds to your local AC power supply. If it does not, consult your dealer or service centre.
2. Connect the power cord to the AC MAINS inlet and the wall outlet. The power supply is now
connected and ready for use.
3. To switch off completely, unplug the power cord from the wall outlet.
- Unplug the power cord from the wall outlet to protect your set during heavy thunderstorms.
Batteries (not included)
Open the battery compartment and insert eight batteries, type R-14, UM-2 or C-cells, (preferably
alkaline) with the correct polarity as indicated by the “+” and “–” symbols inside the compartment.
Batteries contain chemical substances, so they should be disposed of properly.
Incorrect use of batteries can cause electrolyte leakage and will corrode the compartment or cause the
batteries to burst. Therefore:
Do not mix battery types: e.g. alkaline with carbon zinc. Only use batteries of the same type for the set.
- When inserting new batteries, do not try to mix old batteries with new ones.
- Remove the batteries if the set will not be used for a long time.
Installing batteries in the remote control
1. Open the battery cover to remove it.
2. Insert two (AAA) batteries (not included) correctly so that the + and – polarities match the polarity
diagrams inside the battery compartment.
Note:
* About half a year of normal operation can be expected when using the general batteries.
* When the batteries are exhausted, the commander should no longer operate the system. Replace
both batteries with new ones.
* When the commander will not be used for a long time, remove the batteries to avoid damage caused
by battery leakage and corrosion.
* Avoid keeping the commander in extremely hot or humid locations.
* There should be no obstacles between the remote control and the remote sensor and they should be
kept within 30° ranges.
* The remote control’s operating distance is about 0.2 m to 6 m away from the remote sensor.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Konig Electronic HAV-PRCD21 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Konig Electronic HAV-PRCD21 in the language / languages: English, German, Dutch, Danish, French, Italian, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 5,4 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info