588377
3
Zoom out
Zoom in
Previous page
1/4
Next page
1. Cut the appropriate size opening in the ceiling using the template
provided. If the template is not available, cutout dimensions are
provided on the Klipsch website, at www.klipsch.com. Sizes
listed are minimum. If accuracy of cut cannot be achieved,
you may add 1/4” to the dimension. Be careful not to cut
through any existing wiring or plumbing. Avoid compromising
any fire stops between studs.
2. Run speaker wiring (18 gauge minimum) to the openings. Be
sure to comply with all building codes in your area.
3. Attach the wire to the speaker using the wire’s color coding or
markings as a guide to maintain proper polarity.
Speaker Installation
(for New Construction, skip to step #3)
3
4. Insert the speaker assembly into the opening and attach by
tightening the Phillips screws (see illustration). The frame’s
“dogs” will swivel out and “sandwich” the ceiling and frame
together as they are tightened. If you use a power tool to
tighten these screws, please use a low torque setting. Failure
to do so could result in damage to your speaker (see Figure 3)
Figure 1
Figure 2
Figure 3
To maximize performance, install the K L-75 0 2-T H X equally spaced to
either side of the video display. When being used as a center channel,
please locate the speaker as close to the video display as is practical.
The KS-7502-THX should be installed to either side of the listening
position at an equal distance from the listener whenever possible. You
may also install them behind the listening position and achieve good results.
THX Ultra2 7.1 surround systems utilize a surround back channel in
addition to the traditional side surrounds. When configuring such a
system it is suggested to use K L-75 0 2 speakers in the surround back
location.
5. At this point, you may paint the speaker grille before attaching it
to the speaker. Klipsch speakers and grilles are designed to
accept most types of paint. Use the supplied clear paint shield to
protect the speaker baffle and drivers when painting the bezel of
the speaker. Care should be taken to avoid excessive paint
build-up in the grille perforations. Please remove the scrim
material attached to inner surface of the grille by carefully
peeling it out prior to painting. Reinstall scrim after the paint on
the grille is dry.
6. Press the grille into place.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Klipsch THX Ultra2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch THX Ultra2 in the language / languages: English as an attachment in your email.

The manual is 0,73 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info