Manual Klipsch ProMedia 2.1 (page 3 of 12) (English, French, Spanish)

584813

Zoom out

Zoom in

1/12

Subwoofer Level

For CD or DVD output, the optimum position will be indicated by the mark at 10

o’clock on the sub level control. Optimum sub levels and user preference may

vary from game to game. Usually a high bass level is preferred, especially at

low listening levels. Remember to reset the control settings before playing CDs

or ﬁlms on DVD.

CONTROL POD FEATURES

Headphones: The 1/8” stereo headphone output jack, located on the

right-hand side of the control pod, turns off the two satellite speakers and the

subwoofer output. The main volume control will adjust the headphone output.

MP3/Aux: The MP3/Auxiliary input jack is used with portable audio players.

This signal will be mixed with the main source. The input has a +6dB input

sensitivity to help compensate for the lower output voltage of some portable

players. To obtain the proper balance with the main signal, the level adjust-

ments in the computer software and in the portable player will need to be

adjusted. An example would be listening to an MP3 player while surﬁng the net

and hearing associated sounds from various websites. The mixed sound may

not be desirable, and you will ultimately determine how you use this feature.

NOTE: During playback of MP3s, overall sound quality may be perceptibly

degraded compared to other audio sources such as CD. This is caused by the

encoding method and quality of the MP3 ﬁle. It is recommended that MP3 ﬁles

be encoded at a minimum 128 bit rate.

SPECIFICATIONS

(Visit www.klipsch.com for more details)

Satellite Impedance: 4 ohms minimum

Preampliﬁer Control Pod: Subwoofer and Main volume level controls

LED power indicator

MP3/Aux player line input with soundcard

mixing function

Headphone jack

Direct path interface

Satellite: Sealed elliptical two-way enclosure with

25mm metalized polymer dome tweeter

mated to MicroTractrixTM Horn and

3” long-throw mid-bass driver

Subwoofer: Bass-reﬂex enclosure with rear port and

front-ﬁring 8” long-throw driver; slot

tuned port; sixth-order enclosure design

Ampliﬁer: High-efﬁciency power supply and linear

ampliﬁers designed for uncompressed full

power sound

Subwoofer Limiter: Protective limiter function protects the

driver and ampliﬁer from extremely high

volume playback

TROUBLESHOOTING

If no sound, ensure that:

- Power, input, speaker cables connectors and AC power cord are securely attached

- Soundcard software is properly installed and functioning

- Computer sound (control panel) volume is turned up and not muted

- LED glowing

- Headphones are not connected

If one or more speakers have little or no sound, ensure that:

- All cables are connected properly

- Connectors are fully “seated” in soundcard and speakers

- Main and subwoofer level controls are properly adjusted on control pod

- Computer software audio settings are adjusted for proper use

- Computer system’s sound (control panel) volume is turned up

If the satellites or subwoofer exhibit distortion or buzzing:

- Turn down computer’s volume (via control panel), and reduce control pod volume

- Turn down subwoofer’s volume, as program signal may be too strong

- Plug the subwoofer’s power cord into a surge protector

If there is noise or hissing and the volume is low even when the main volume is up:

- Turn up computer’s sound volume (via control panel)

- Turn down main volume on control pod to compensate

- Ensure that software/hardware is properly installed and operating

If there is computer monitor interference:

- Make sure the sub is positioned at least 3 feet (1m) from the computer monitor

- Increase the distance between the satellite speakers and the computer monitor

For more detailed information and FAQs, please visit www.klipsch.com.

FCC AND CANADA EMC COMPLIANCE INFORMATION

Approved under the veriﬁcation provision of FCC Part 15 as a Class B Digital Device.

This device complies with part 15 of the FCC Rules. Operation is subject to the

following two conditions:

(1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause

undesired operation.

NOTE: This equipment has been tested and found to comply with the limits

for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that

to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

- CAUTION: Changes or modiﬁcations not expressly approved by

manufacturer could void the user’s authority to operate this device.

This Class B digital apparatus complies with Canadian ICES-003.

Cet appareil numérique de la classe B est conforme à la norme NMB-003 du

Canada.

Speciﬁcations are subject to change without notice.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch ProMedia 2.1 in the language / languages: English, French, Spanish as an attachment in your email.

The manual is 1,62 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klipsch ProMedia 2.1 Manual

Product: