Manual Klipsch ProMedia 2.1 Wireless (page 3 of 8) (English)

584814

Zoom out

Zoom in

1/8

IMPORTANT SAFETY INFORMATION

1. READ these instructions.

2. KEEP these instructions.

3. HEED all warnings.

4. FOLLOW all instructions.

5. DO NOT use this apparatus near water.

6. CLEAN ONLY with dry cloth.

7. DO NOT block any ventilation openings. Install in accordance with the manufacturer’s instructions.

8. Do not install near any heat sources such as radiators, heat registers, stoves, or other appara-

tus (including ampliﬁers) that produce heat.

9. DO NOT defeat the safety purpose of the polarized or grounding type plug. A polarized plug has

two blades with one wider than the other. A grounding type plug has two blades and a third

grounding prong. The wider blade or the third prong are provided for your safety. If the provided

plug does not ﬁt into your outlet, consult an electrician for replacement of the obsolete outlet.

10. PROTECT the power cord from being walked on or pinched, particularly at plugs, convenience

receptacles, and the point where they exit from the apparatus.

11. ONLY USE attachments/accessories speciﬁed by the manufacturer.

12. USE only with a cart, stand, tripod, bracket, or table speciﬁed by the manufacturer,

or sold with the apparatus. When a cart is used, use caution when moving the cart/

apparatus combination to avoid injury from tip-over.

13. UNPLUG this apparatus during lightning storms or when unused for long periods of time.

14. REFER all servicing to qualiﬁed service personnel. Servicing is required when the apparatus

has been damaged in any way, such as power-supply cord or plug is damaged, liquid has been

spilled or objects have fallen into the apparatus, the apparatus has been exposed to rain or

moisture, does not operate normally, or has been dropped.

15. DO NOT expose this apparatus to dripping or splashing and ensure that no objects ﬁlled with

liquids, such as vases, are placed on the apparatus.

16. To completely disconnect this apparatus from the AC Mains, disconnect the power supply cord

plug from the AC receptacle.

17. The mains plug of the power supply cord shall remain readily operable.

The exclamation point, within an equilateral triangle, is intended to alert the user to

the presence of important operating and maintenance (servicing) instructions in the

literature accompanying the product.

The lightning ﬂash with arrowhead symbol within an equilateral triangle, is intended

to alert the user to the presence of uninsulated “dangerous voltage” within the

product’s enclosure that may be of sufﬁcient magnitude to constitute a risk of

electrical shock to persons.

WARNING: To reduce the risk of ﬁre or electrical shock, do not expose this apparatus to rain or moisture.

WARNING: No naked ﬂame sources – such as candles – should be placed on the product.

WARNING: This product is intended to be operated ONLY from the AC Voltages listed on the back

panel or included power supply of the product. Operation from other voltages other than those

indicated may cause irreversible damage to the product and void the products warranty. The use

of AC Plug Adapters is cautioned because it can allow the product to be plugged into voltages

in which the product was not designed to operate. If the product is equipped with a detachable

power cord, use only the type provided with your product or by your local distributor and/or

retailer. If you are unsure of the correct operational voltage, please contact your local distributor

and/or retailer.

CAUTION: Place the equipment near a main power supply outlet and make sure that you can

easily access the power breaker switch.

PACKING LIST

2 Satellite speakers with pedestals and wires attached

1 Control pod, attached to one satellite speaker

1 Subwoofer

1 USB Wireless Transmitter

1 4-inch USB Adapter Cable

1 Packet of rubber isolation feet

1 Owner’s manual

DOES NOT NEED SOFTWARE DISC FOR OPERATION

SPEAKER PLACEMENT

1. The ProMedia 2.1 Wireless system uses a short-range, line-of-sight

transmitter. It was not designed to be used through walls or at distances

greater than about 30 feet.

2. For best imaging with movies and games, the two satellite speakers should

be positioned on each side the video monitor. For music listening, the satellite

speakers can be placed in any convenient location within 30 feet of the

computer with the USB Transmitter. For best sound and imaging place the

speakers near ear level and 3-5 feet apart. To wall mount, the pedestal stands

may be removed by unscrewing the 1/4” 20-thread bolt, which accommodates

a wide variety of wall brackets available through stereo and appliance stores.

Klipsch WB-1 wall brackets are available at www.klipsch.com.

3. Place the subwoofer on the ﬂoor within the cables’ reach of the satellite speak-

ers. The subwoofer must be placed on the ﬂoor near a wall with the rear panel

toward the wall. Do not cover up the sub driver or front port of the enclosure

and be sure to provide enough ventilation to the rear of the subwoofer. It

is normal for this panel to be warm to the touch. The subwoofer should be

at least 3 feet (1m) from a CRT monitor to avoid interference. Placing the

subwoofer in a corner can further enhance bass output. Subwoofer placement

will ultimately be determined by what sounds best to your ear.

4. Speaker or power cables running across an area of heavy foot trafﬁc should

be positioned against a wall or corner and secured with tape.

SPEAKER CONNECTION DIAGRAM

1. Do not plug in the AC power cord until your computer/audio system is set up.

2. Care should be advised concerning the cables at back of sub. Bumping them

could cause damage.

3. Connect the DIN plug to the sub from the control satellite preamp. Wire

should hang down from plug.

4. Connect the speakers by inserting the tinned wire leads into the subwoofer.

The solid black wires (-) connect to the black spring clips; the black wires

with red stripes (+) to the red spring clips.

5. Plug the AC power cord into a wall outlet.

6. Plug headphone mini stereo plug in headphone jack, if desired.

7. Plug stereo mini plug into MP3/Aux jack. Plug stereo mini plug into MP3

player (for example).

If you don’t want to use the wireless, connect computer to Aux In. See Control Pod Features.

Cable not included.

USB WIRELESS TRANSMITTER

1. Perform main system setup as described above.

a. Set up the system, plug in AC power cord and turn on power switch on rear

panel of subwoofer.

b. The red LED on rear panel of subwoofer should begin ﬂashing.

2. Connecting the USB Wireless Transmitter.

a.The computer should already be up and running

WARNING

RISK OF ELECTRIC SHOCK.

DO NOT OPEN.

WARNING: Do Not Open! Risk of Electrical Shock. Voltages in this

equipment are hazardous to life. No user-serviceable parts inside.

Refer all servicing to qualified service personnel.

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch ProMedia 2.1 Wireless in the language / languages: English as an attachment in your email.

The manual is 1 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Klipsch ProMedia 2.1 Wireless Manual

Product: