584806
3
Zoom out
Zoom in
Previous page
1/11
Next page
Page 4 Page 5
Preparing the LoudspeakerGetting Started
Unpacking
Please follow the unpacking instructions fully and in the order shown below. These loudspeakers are
heavy! Do not lift or move these speakers by yourself. Always have someone help you.
1
3
5
4
2
Open the carton aps
Lightly tape each ap to the box
with short pieces of tape
Remove the top packing piece
Remove the Grille box
Remove the Accessories box
Remove the Owners manual
and gloves
Carefully invert the carton
Lift o the carton
Lift o the center and base packing pieces
The loudspeaker is
ready for connection
The grille box contains: one upper grille; one lower grille.
The Accessories box contains: four long spikes; four short spikes; four spike seats; two bi-wiring
straps: one Allen wrench.
There is a pair of gloves located in a pocket in the side of the packing carton beside the Owners manual.
Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch
dealer and the transport contractor for action.
Connection Procedure:
There is a specic procedure to be followed:
Switch o and unplug the amplier/s and all source electronics from the mains power.
Place both loudspeakers in the general area where you want them.
Place each loudspeaker on its side, in its partial packing, as described in the unpacking instructions.
Connect each loudspeaker.
Attach the spikes following the instructions under the “nalizing the assembly section of this manual.
Position the loudspeaker cable between the rear spikes.
Stand the loudspeaker upright, using great care not to damage connecting cables, furniture or the oor.
Lift o the top packing piece and the protective cloth bag.
Run both sets of loudspeaker cables to the amplier.
Connect the amplier.
Finalize the position of the loudspeakers.
Finally, t the grilles (if desired).
TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND.
TO PRESERVE THE FINISH, USE THE PROVIDED GLOVES WHEN HANDLING YOUR LOUDSPEAKERS.
Fitting and Removing the Grilles
The grilles are magnetically attached to the cabinet. Specially designed magnets
are housed inside the front wall of the loudspeaker, so that if you wish to operate
the loudspeaker with the grilles removed, no grille mounting hardware is visible.
This preserves the smooth lines of the loudspeaker.
To t the grilles: Fit the top grille rst and line it up with the top and sides of the
cabinet. There is a small lip on the top of the grille that should rest on the top of
the cabinet. Now, t the lower grille, lining up the top of the lower grille with the
bottom of the upper grille. You may now remove the top grille if you wish.
Although operating the P-39F loudspeakers with the grilles on or o is a matter
of personal taste, moving or connecting the loudspeakers should always be done
with the grilles removed. Be especially careful not to touch the drive units.
What’s in the box?
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Klipsch P-39F at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch P-39F in the language / languages: English as an attachment in your email.

The manual is 1,9 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Klipsch P-39F

Klipsch P-39F User Manual - Spanish - 100 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info