584811
3
Zoom out
Zoom in
Previous page
1/11
Next page
Page 4 Page 5
Preparing the LoudspeakerGetting Started
Unpacking (P-38F / P-37F)
Please follow the unpacking instructions fully and in the order shown below. These loudspeakers are
heavy! Do not lift or move these speakers by yourself. Always have someone help you.
1
3
5
4
2
Open the carton aps
Lightly tape each ap to the box
with short pieces of tape
Remove the top packing piece
Carefully invert the carton
Lift o the carton
Lift o the center and base packing pieces
The loudspeaker is
ready for connection
The grille box contains: one upper grille; one lower grille, (P-38F / P-37F) or one single-piece grille
(P-17B, P-27C and P-27S).
The Accessories box for P-38F and P-37F contain: four long spikes; four short spikes; four spike col-
lars; four spike seats; one Allen wrench.
The Accessories box for P-27C contains: two short front spikes; one short-barrel rear spike; one
long-barrel rear spike; three spike collars; three spike seats; one Allen wrench.
The P-17B and P-27S do not have an accessory box, but do include an Allen wrench with the
owners manual packet.
There is a pair of gloves located in a pocket in the side of the packing carton under the owners manual.
Identify all the components. If any item is missing or damaged, report this immediately to your Klipsch
dealer and the transport contractor for action.
Connection Procedure:
There is a specic procedure to be followed:
Switch o and unplug the amplier/s and all source electronics from the mains power.
Place both loudspeakers in the general area where you want them.
Connect each loudspeaker following the instructions under the connecting the loudspeakers” section of
this manual.
Attach the spikes, following the instructions under the “nalizing the assembly section of this manual.
Run both sets of loudspeaker cables to the amplier.
Connect the amplier.
Finalize the position of the loudspeakers.
Finally, t the grilles (if desired).
TAKE CARE NOT TO TOUCH THE DRIVE UNITS WHEN YOU MOVE THE LOUDSPEAKERS AROUND.
TO PRESERVE THE FINISH, WHEN HANDLING YOUR SPEAKERS, USE THE GLOVES THAT ARE PROVIDED.
Fitting and Removing the Grilles
The grilles are magnetically attached to the cabinet. Specially designed magnets
are housed inside the front wall of the loudspeaker, so that if you wish to operate
the loudspeaker with the grilles removed, no grille mounting hardware is visible.
This preserves the smooth lines of the loudspeaker.
To t the grilles: Fit the top grille rst and line it up with the top and sides of the
cabinet. For the P-38F, P-37F and P-17B there is a small lip on the top of the grille
that should rest on the top of the cabinet. Now, t the lower grille, lining up the
top of the lower grille with the bottom of the upper grille. You may now remove
the top grille if you wish. (The P-17B, P-27C and P-27S have a single one-piece
grille only.)
Although operating the loudspeakers with the grilles on or o is a matter
of personal taste, moving or connecting the loudspeakers should always be done
with the grilles removed. Be especially careful not to touch the drive units.
What’s in the box?
Remove the Grille box
Remove the Accessories box
Remove the Owners manual
and gloves
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Klipsch P-27S at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Klipsch P-27S in the language / languages: English as an attachment in your email.

The manual is 1,74 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info