How to enter option adjustment mode
After using the DishDrawer® you may want to
change some of the preset options to suit your needs.
The settings for Rinse Aid, Water Softener, Auto
Power, End of Wash Programme Beeps, Closed
Drawer, Clean Dish Indicator and Dry Enhancement
Mode options can be changed.
1. Press the POWER button to turn the
DishDrawer® to the Normal Operating Mode.
2. Press and hold the ECO and LOCK buttons for 5
seconds. When the buttons have been correctly
pressed, one long beep is emitted.
3. Release the LOCK and ECO buttons.
4. Use the appropriate buttons on the control panel
to make the necessary adjustments. These are
explained below.
5. Once the changes have been made, press the
POWER button to save the change.
How to adjust the rinse aid setting
1. Enter the Option Adjustment Mode as explained
previously. The light above the START/PAUSE
button is red to indicate this setting has been
chosen.
2. The current rinse aid setting is shown on the wash
programme indicator in red lights. If four red lights
are lit on the wash programme indicator then the
rinse aid setting is at four.
3. Press the LOCK button to increase or decrease
the rinse aid setting, the red lights will scroll up to 5
and then start from 1 again.
4. Once you have selected the desired rinse aid
setting, press the POWER button to save the
change.
Example of Rinse Aid set to 4.
How to adjust the water softener setting
1. Enter the Option Adjustment Mode as explained
previously.
2. Press the START/PAUSE button until the light above
the START/PAUSE button is green, if it is not, press
the POWER button and start again. The current
water softener setting is shown on the wash
programme indicator in red lights. If four red lights
are lit, then the water softener is set to four.
3. Press the LOCK button to increase or decrease the
water softener setting. For example, if the water
hardness is 500ppm, there should be four red lights
lit.
4. Once you have selected the desired water softener
setting, press the POWER button to save the
change.
Example of the Water Softener set to 4.
How to remove the auto power option
When the DishDrawer® leaves the factory, it is
programmed to automatically turn itself on whenever
the drawer is opened. The DishDrawer® will not
start washing until the drawer is closed and the
START/PAUSE button has been pressed. If you do not
want the DishDrawer® to turn itself on automatically,
this feature can be turned off.
1. Enter the Option Adjustment Mode as explained
previously.
2. Press the START/PAUSE button twice. The lights
above the START/PAUSE button will be green and
the ECO button will be red. If it is not, press the
POWER button to start again.
3. Press the LOCK button to turn the Auto Power
feature on or off. If all the red lights on the wash
programme indicator are off then the Auto Power
feature has been turned off.
4. Press the POWER button to save the change.
Auto Power On
Auto Power Off
Option adjustment mode
16
