166268

Kicker zr 360 Manual

10
Zoom out
Zoom in
Previous page
1/12
Next page
10
TROUBLE SHOOTING
Note: It is normal for the yellow trouble LED to blink when the amplifier is turned on or off.
This is a function of the protection circuit looking for trouble.
Red LED power indicator off, yellow trouble indicator off.
With a Volt Ohm Meter (VOM):
• Check +12 Volt terminal
• Check Ground terminal
• Check for +12 Volts at remote turn-on terminal
Red LED power indicator on, yellow trouble indicator off:
• Make sure there is a module in place and the settings are correct
• Check RCA and speaker connections
• Test speaker outputs with a known good speaker
• Substitute a known good signal source
Yellow trouble LED on, red power indicator off:
1. Amp is very hot - Thermal protection is engaged. Verify that speaker
load impedance is not below specified minimums. Check area
around amplifier for objects which may restrict air flow and proper
cooling. If this continues to be a problem, take vehicle to an
authorized Kicker dealer for evaluation.
2. Amp is not too hot - Overcurrent protection is engaged, red power LED
blinks every two seconds. This indicates that there is a short in the
speaker wiring. Locate short using a VOM by checking between
speaker positive and negative. If the amplifier is used in stereo, try
disconnecting one channel at a time to help isolate which channel is shorted.
3. Amp is not too hot - Voltage to amp is not within the 9-16 volt operating
range. If the vehicle’s charging system goes over 16 volts, the amp
will shut off. If the voltage gets too low, the amp will not operate.
Using a VOM identify the voltage problem and rectify.
Alternator noise (whistling sound that follows the engine RPM).
• Make sure that the amp case is not grounded.
• Make sure that the source has a good ground.
• Check routing of the RCA cable. Try substituting another RCA
cable routed in a different location in the vehicle.
• Check gain setting to make sure that it is not too high.
Stereo image is unfocused and bass is reduced.
Check system phasing by turning the balance control from the left to
the right. If the bass is more prominent when turned to either side,
check speaker wiring for proper positive and negative connections.
Reverse connections on one channel if necessary.
CAUTION: When jump starting the vehicle, be sure that connections made with jumper
cables are correct. If improper connections are made, it can result in blown amplifier fuses
as well as failure in other systems in the vehicle.
If you have more questions about the installation of your new KICKER component, see the
Authorized KICKER Dealer where you purchased your component. You may also call our
… 10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker zr 360 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker zr 360 in the language / languages: English as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info