508867
17
Zoom out
Zoom in
Previous page
1/20
Next page
33
SX .2 Series Amplifiers
Specifications
Performance
Model SX400.2 SX500.2 SX600.2 SX900.2
RMS Power
In Watts, All Channels Driven
@ 13.8V, 4 Stereo, 0.02% THD 88 x 2 113 x 2 138 x 2 213 x 2
@ 13.8V, 2 Stereo, 0.2% THD 175 x 2 225 x 2 275 x 2 425 x 2
@ 13.8V, 4 Mono, 0.4% THD 350 x 1 450 x 1 550 x 1 850 x 1
Dynamic Power
In Watts, All Channels Driven
@ 14.4V, 4 Stereo, 1% THD 100 x 2 125 x 2 150 x 2 225 x 2
@ 14.4V, 2 Stereo, 1% THD 200 x 2 250 x 2 300 x 2 450 x 2
@ 14.4V, 4 Mono, 1% THD 400 x 1 500 x 1 600 x 1 900 x 1
Length With EndKaps 16” 19.25” 22.5” 25.75”
(40.64cm) (48.90cm) (57.15cm) (65.41cm)
Fusing 25A x 2 30A x 2 40A x 2 40A x 3
Recommended Power & Ground Wire 4 GA 4 GA 4 GA 2 GA
32
SX .2 Series Amplifiers
Specifications
Kompressor
Here is a brief explanation of each KOMPRESSOR setting.
Contour - This preset applies expansion below the threshold
point to provide a fuller sound at lower volume levels. Effect
decreases at higher volume levels. Nice effect for someone
wanting a fuller sound at low to moderate listening levels.
ATTACK - This preset applies expansion above the threshold
point to provide a nice quick punch or attack to the music.
Effect increase with higher volume levels. Like music with a
quick and punchy sound? Give this one a try.
Red-line - Provides a quick clamp to dynamic peaks while
still allowing a full sound to come through. Effect increases
at higher volume levels. Like to play it loud but want to
protect your speakers? Want low level details to come
through over road noise? Want a more even volume level to
your music? All can be achieved with this preset.
OFF - Pretty much says it all. This turns the KOMPRESSOR
off. This is the factory default setting.
After selecting your KOMPRESSOR setting you can adjust its
effect using the KOMPRESSOR ADJUSTMENT (
KOMP ADJ.)
setting located in the SYSTEM menu. There you can change
the threshold point for each of these settings to customize
the KOMPRESSOR effect to fit your speakers, car or personal
tastes.
A few words on the Kompressor. The effect is most
noticeable in the bass area of your music and the
descriptions above apply to that area of your music
(Bass/Midbass). You can use the Kompressor in any amplifier
configuration (Low Pass, High Pass, Band Pass or Full Range)
but we feel the best results are obtained when with the amp
is in a Low Pass (subwoofer) or Band Pass (midbass) situation.
A few exceptions to this rule are:
The
red-line setting is good for use in any configuration
as it helps control dynamic peaks and limit distortion at
higher output levels.
The
contour setting is also another good all around use
setting and when used in Full Range or High Pass
configurations tends to enhance the vocal and top end of
the music. Great for helping to cover up interior noise.
The
ATTACK setting is really geared for bass and midbass
duty.
The possibilities are almost endless! Tweak away!
17


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker SX500.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker SX500.2 in the language / languages: English as an attachment in your email.

The manual is 1,84 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info