166250

Kicker ix 406 impulse Manual

2
Zoom out
Zoom in
Previous page
1/12
Next page
Wiring
The preferred method of bringing input signal in to the amplifier is with RCA cables from a quality tape or CD
player. A high (speaker) level input signal may also be used if your factory deck or aftermarket source does not
have low level RCA jacks. It is not recommended to mix high and low level inputs. Engine noise in the system will
probably result.
ome of the system possibilities are shown in the System Diagrams section of this manual.
When working with power connections always hook up the ground wire first and disconnect the ground wire last.
Never make any wiring changes with the amplifier powered up.
The chassis mounted fuse(s) are in place to protect the circuitry of the amplifier in the event of major trouble. An
in-line fuse must be installed within 18 inches of the battery to protect the power wire used to supply current to
the amplifier. For the Kicker Impulse IX406 amplifier a fuse value of 60A and 8 gauge power wire are recommended.
If the power wire is longer than 10 feet, it is recommended that the wire size be 4 gauge to reduce losses.
Any time that a power wire goes through a metal panel such as the firewall, or if there is any chance of abrasion,
it is necessary to use a grommet or other suitable form of protection to avoid shorts.
The ground wire should be at least 8 gauge, as short as possible and attached to the body of the vehicle. The
ground point must be free from paint and corrosion.
Mounting the IMPULSE Amplifier
After determining an appropriate mounting
location which provides good air circulation and
access to the end panel controls, use the supplied
screws and washers to firmly mount the amplifi-
er.The amplifier chassis can be used as a template
for the screw locations. Check to make sure that
the mounting screws will not damage any compo-
nents on the back side of the chosen mounting
surface.
If a vertical mounting surface is chosen, we rec-
ommend that the heatsink fins run vertically as
shown for improved cooling.
2 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kicker ix 406 impulse at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kicker ix 406 impulse in the language / languages: English as an attachment in your email.

The manual is 0,99 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info