Assembly Instructions
Before assembling or using the table-tennis table, please read the following instructions carefully. They contain important
information for use and maintenance of the equipment as well as for your personal safety. Keep these instructions in a
safe place for maintenance purposes or for ordering spare parts.
All KETTLER products are designed in accordance with the latest safety regulations and undergo a constant process of quality control
during manufacturing. The knowledge gained in this process is used to constantly improve and develop our products. In order to offer our
customers the very best in product quality, we reserve the right to make technical changes at any time. In spite of this, should you have
any cause for complaint, please contact your KETTLER dealer.
GB
Note on Safety
■ The table-tennis table should be used only for its intended pur-
pose, i.e. for playing with suitable table-tennis bats and balls.
■ All other uses are prohibited and may be dangerous. The man-
ufacturer cannot be held liable for damage or injury caused by
improper use of the table.
■ Damaged or worn components may endanger your safety or
shorten the lifespan of the table-tennis table. Replace worn or
damaged components immediately and remove the table from
use until this has been done. Use only spare parts manufactured
by KETTLER.
■ The table-tennis table complies with all safety regulations. Incor-
rect repairs, alterations to the design (removal of original parts,
addition of other components etc.) may endanger the safety of
the user.
■ Instruct other persons (in particular children) using the table in its
correct use, and draw their attention to any potential source of
danger, especially when setting up or dismantling the table.
■ Caution: While assembly of the product keep off children’s reach
(Choking hazard - contains small parts).
■ When setting up or dismantling the table, stay clear of its folding
radius.
■ When folded up, the table-tennis table presents a large surface
to the wind. For this reason, ensure that it is stored in a sheltered
position.
■ The table-tennis table may be pushed only into the transport po-
sition because there is otherwise a danger of injury.
■ The unit complies with the standard EN 14468–1:2004.
■ Depending on frequency of use, check all screws, bolts etc. reg-
ularly to ensure that they are in good condition.
■ In case of enquiry, please contact your KETTLER dealer.
Handling the equipment
■ Do not use the table-tennis table until it has been fully and cor-
rectly assembled and checked.
■ Ensure that table-tennis tables which are not weatherproof are
not exposed to dampness or rain. Keep them well away from di-
rect sources of heat. Should the surface become warped, lay the
table on a level surface for a few days.
■ Set the table up on a level surface.
■ Do not cover it with plastic foil, under which condensation may
form. We recommend the weatherproof KETTLER tarpaulin, art.
no. 7032-300.
■ For practising without a partner, the table halves can be folded
up singly.
■ For more information on the sport of table-tennis, you are referred
to the specialist literature on the subject.
■ Do not use corrosive or abrasive materials to clean the equipment.
Ensure that such materials are not allowed to pollute the environ-
ment. In most cases, a slightly dampened cloth is sufficient.
■ 07178-800: Mark the playing surface with table chalk only. A
lightly dampened, clean cloth is sufficient for cleaning purposes.
Clean the playing surface from time to time with a wet sponge,
especially if the markings have been on the playing surface for a
long time. Add a splash of neutral cleaning agent to the cleaning
water if desired. Do not use scouring agents under any circum-
stances! Next, go over the playing surface with a squeegee with
a rubber strip, and dry it with an absorbent cloth afterwards.
■ Waste Disposal: KETTLER products are recyclable. At the end of
its useful life please dispose of this article correctly and safely
(local refuse sites).
Ersatzteilbestellung
Geben Sie bei Ersatzteilbestellungen bitte die vollständige Artikel-
nummer, die Ersatzteilnummer, die benötigte Stückzahl sowie die
Seriennummer (siehe Ersatzteilzeichnung) an.
Bestellbeispiel: Art.-Nr. 07138-650 / Ersatzteil-Nr. 94130118/ 2
Stück / Seriennummer: ........
Wichtig: Zu verschraubende Ersatzteile werden grundsätzlich ohne
Verschraubungsmaterial berechnet und geliefert. Falls Bedarf an
entsprechendem Verschraubungsmaterial besteht, ist dieses durch
den Zusatz „mit Verschraubungsmaterial“ bei der Ersatzteilbestel-
lung anzugeben.
Heinz KETTLER GmbH & Co. KG
SERVICECENTER
Henry-Everling-Str. 2 +49 (0)2307 974-2111
D-59174 Kamen +49 (0)2307 974-2295
www.kettler.de Mail: service.sport@kettler.net
KETTLER Austria GmbH
Ginzkeyplatz 10 +43 662 620501 0
5020 Salzburg +43 662 620501 20
www.kettler.at Mail: office@kettler.at
Trisport AG
Im Bösch 67
CH - 6331 Hünenberg
Servicehotline Schweiz: 0900 785 111
www.kettler.ch
