159529
61
Zoom out
Zoom in
Previous page
1/64
Next page
61
Knowledge section
In case of difficulty
RemedySymptom Cause
General
Remote control operation is
not possible.
÷ Batteries are exhausted.
÷ The remote control is too far away
from the system, the controlling angle
is deviated or there is an obstacle in
between.
÷ There is no tape or CD set in the
component to be played.
÷ An attempt is made to play the cas-
sette deck which is recording some-
thing.
÷ The MULTI CONTROL setting mode
is activated.
÷ Replace with new batteries.
÷ Operate the unit within the remote
controllable range.
÷ Set a tape or CD in the component to
be played.
÷ Wait until the recording ends.
÷ Cancel the MULTI CONTROL setting
mode.
Remote control unit
RemedySymptom Cause
No operation occurs when
an operation key is pressed.
÷ The MULTI CONTROL setting mode
is activated.
÷ Cancel the MULTI CONTROL setting
mode.
CAUTION :
Use of controls or adjustments or performance of proce-
dures other than those specified herein may result in
hazardous radiation exposure.
In compliance with Federal Regulations, following are
reproductions of labels on, or inside the product relating to
laser product safety.
For the U.S.A.
Location: Back Panel
FCC WARNING
Note to CATV system installer
KENWOOD CORPORATION
2967-3, ISHIKAWA-CHO,
HACHIOJI-SHI,TOKYO, JAPAN
KENWOOD CORP. CERTIFIES THIS EQUIPMENT
CONFORMS TO DHHS REGULATIONS NO. 21 CFR
1040.10, CHAPTER 1, SUBCHAPTER J.
This reminder is provided to call the CATV system installer's
attention to Article 820-40 of the NEC that provides guide-
lines for proper grounding and, in particular, specifies that
the cable ground shall be connected to the grounding sys-
tem of the building, as close to the point of cable entry as
practical
NOTE:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful
interference unless the modifications are expressly approved in the instruction manual. The user could lose the authority
to operate this equipment if an unauthorized change or modification is made.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential instal-
lation. This equipment may cause harmful interference to radio communications, if it is not installed and used in accor-
dance with the instructions. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
–– Reorient or relocate the receiving antenna.
–– Increase the separation between the equipment and receiver.
–– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
–– Consult the dealer or an experienced radio / TV technician for help.
$
$
%
%
61


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood xd 803 8 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood xd 803 8 in the language / languages: English, Dutch as an attachment in your email.

The manual is 1,53 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info