165398

Kenwood kdc d 300 Manual

13
Zoom out
Zoom in
Previous page
1/15
Next page
— 13 —
What might seem to be a malfunction in your unit may just be the result of slight misoperation or miswiring. Before
calling service, first check the following table for possible problems.
SOLUTIONPOSSIBLE CAUSEPROBLEM
No sound can be heard, or the
volume is low.
The fader or balance settings are set all the way to one
side.
Reset the fader or balance settings.
Nothing happens when the
buttons are pressed.
The computer chip in the unit is not functioning normally. Press the reset button on the centre unit.
Attenuator is turned on. Turn off Attenuator.
A CD ejects as soon as it is
loaded.
The CD is upside-down. Load the CD with the labeled side up.
The CD is quite dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
The sound skips on a CD. The CD is scratched or dirty. Clean the CD, referring to the section on "Cleaning CDs" (see
p. 5).
A track will not play. Random play has been selected. Turn off random play.
The disc control mode cannot
be selected.
No cable has been connected to the disc changer input
terminal on the unit.
Connect the control cable to the disc changer input terminal
on the centre unit.
Troubleshooting Guide
No CD has been inserted. For centre units brought on to the market from 1999
onwards, it is not possible to switch to the CD mode unless
a CD has already been inserted.
The spectrum analyser is not
displayed.
The speaker input cable is not connected. Refer to the "Connections" section, and connect the cable.
The fader setting has been adjusted to the rear side. Adjust the fader control on the centre unit to the centre
position.
The analyser display level has been set too low. Adjust it to a higher level.
The volume is too low. Raise the volume, or alternatively, adjust the analyser display
level to a higher level.
5 minutes have elapsed since the panel dropped open. When 5 minutes have elapsed since the panel dropped
open, the disc will automatically stop playing.
The system will not enter the
Menu mode.
The system is not in CD play mode. If the main unit is not in CD play mode, it will not go into the
Menu mode.
… 13


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kenwood kdc d 300 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kenwood kdc d 300 in the language / languages: English as an attachment in your email.

The manual is 0,28 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info