686270
10
Zoom out
Zoom in
Previous page
1/26
Next page
EN
2.7 Filler wire
The machine is delivered with the welding gun connected to the positive pole (+) making it
suitable for welding with solid steel, stainless steel, aluminium and CuSi ller wires without
extra adjustments.
2.7.1 Changing the feed roll groove
When the machine leaves factory, the feed roll groove is set for welding with ller wires of
0.8–1.0 mm diameter. The feed roll groove must be changed, if you use 0.6 mm thick ller wire.
Changing the feed roll groove
1., 9.
7.
2., 4.
3.
5., 8.
6.
1. Release the pressure control lever.
2. Switch the machine on from the main switch.
3. Press the welding gun trigger and drive the feed roll in such a position that the locking screw
is clearly visible and can be accessed.
4. Switch the power o from the main switch.
5. Release the feed roll locking screw with a 3.0 mm Allen wrench approximately half a
turn.
6. Pull the feed roll from its shaft.
7. Turn the feed roll around and reinstall it to the shaft all the way to the bottom stop, making
sure that the screw is parallel to the at area ground onto the shaft.
8. Tighten the feed roll locking screw.
9. Close the pressure control lever.
MinarcMig Evo 170, Evo 200
8
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemppi MinarcMig Evo 170 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemppi MinarcMig Evo 170 in the language / languages: English as an attachment in your email.

The manual is 3,18 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Kemppi MinarcMig Evo 170

Kemppi MinarcMig Evo 170 User Manual - Dutch - 26 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info