778343

Kemper 1060RC Manual

3
Zoom out
Zoom in
Previous page
1/4
Next page
1060RC
DT istr (1060RC) 11/2020 – REV 1 11/2020 3 / 4
ISTRUZIONI GENERALI DI MONTAGGIO E D'UTILIZZO
1. Controllare che la manopola del gas (6) sia chiusa completamente.
2. Controllare la presenza ed il buono stato della guarnizione all’interno della sede (8).
3. Inserire ed avvitare completamente la cartuccia all’interno dell’apposito porta cartuccia (5).
4. Aprire leggermente la manopola del gas (6) in senso antiorario e premere il pulsante dell’accensione (3). Ripetere l'operazione
in caso di mancata accensione.
5. Aumentare la potenza dell'apparecchio girando la manopola del gas (6) in senso antiorario. Per diminuire la potenza ruotare
la manopola del gas (6) in senso orario.
6. Per spegnere l’apparecchio, ruotare la manopola del gas (6) in senso orario fino alla chiusura della e valvola raggiungendo
così lo spegnimento dell’applicazione.
SOSTITUZIONE DELLA CARTUCCIA
1. La cartuccia deve essere sostituita all’esterno, in un ambiente ben aerato, lontano da fiamme libere, fiammelle pilota, piastre
elettriche e lontano da altre persone.
2. Assicurarsi che il rubinetto sia chiuso, svitare la cartuccia dall’apparecchio, controllare la presenza ed il buono stato della
guarnizione tra l’apparecchiatura e la cartuccia, avvitare la nuova cartuccia nell’apparecchio.
3. Mai gettare una cartuccia vuota nel fuoco.
SISTEMAZIONE DELL'APPARECCHIO
Prima di riporre o trasportare l‘apparecchio, svitare sempre la cartuccia dall’apparecchio.
Se l’apparecchio non viene usato, conservarlo in un posto ben ventilato, asciutto e privo di polvere.
Prima di riporre l’apparecchio in un luogo sicuro e asciutto, fare attenzione che si sia raffreddato e che abbia il volantino del gas
(6) chiuso.
MANUTENZIONE - RIPARAZIONE
1. Per pulire il corpo del vostro apparecchio, utilizzate un batuffolo di cotone imbevuto d'acqua calda e sapone. Mai utilizzare
dei prodotti abrasivi.
2. Per pulire il bruciatore, utilizzate una spazzola morbida.
Tutte le domande d'intervento dei servizi assistenza sono da formulare ai ns. centri di produzione di Parma – Via Prampolini, 1/Q,
43044 Lemignano di Collecchio – Tel. +39 0521/957111 – Fax +39 0521/957195 - www.kempergroup.it - info@kempergroup.it
GB
Read these instructions for use carefully so as to familiarize yourself with the appliance before connecting it to its gas cartridge or
gas cylinder. Keep these instructions for future reference.
GENERAL WARNING / IMPORTANT
1. ART 1060RC: This device works only with direct pressure gas cartridge KEMPER 580SMINI.
2. It can be dangerous to try to use other gas cartridges.
3. Make sure the valve is closed before handling the equipment.
4. Always check that the seal, between the device and the cartridge, is in place and in good condition before connecting it to the
gas container.
5. Never use appliances with worn or damaged seals.
6. The appliance should be operated away from flammable materials and at a distance of 70 cm from furniture, walls and ceiling.
7. If there is a leak on your appliance (smell of gas) take it outside immediately into a well ventilated location, where the leak may
be detected and stopped. If you need to check for leaks on your appliance, do it outside. Do not try to detect leaks using
flames, use our item Revelgas 1726 or soapy water.
8. Do not modify the device: it can be dangerous and void the warranty and all liability.
9. Do not use the appliance if not complete all of its components.
10. Do not use an appliance which is leaking damaged or which does not operate properly.
11. CAUTION: Accessible parts may become very hot. Keep young children away from the appliance.
12. Ensure that the appliance is used in a well-ventilated area and that national requirements are being met, in order to ensure a
good supply of air for combustion and to prevent the formation of mixtures with dangerous levels of unburned gas.
GENERAL INSTRUCTIONS FOR USE AND ASSEMBLY
1. Check that the gas knob (6) is completely closed.
2. Check the presence and good condition of the seal inside the valve’s threaded area (8).
3. Insert and screw tight the cartridge iside the cartridge housing (5).
4. Slightly open the gas knob (6) counterclockwise and press the ignition button (3). Press again the ignition button in case of
appliance is not ignited.
5. Increase the power of the appliance by turning the gas knob (6) counterclockwise. To decrease the appliance power, turn the
gas knob (6) clockwise.
6. To turn off the appliance, turn the gas knob (6) clockwise until the valve closes.
CARTRIDGE REPLACEMENT
1. The cartridge must be replaced in a well ventilated area, outside, away from open flames, pilot flames and away from other
people.
2. Make sure the valve is closed, unscrew the empty cartridge from the appliance, check the presence and condition of the seal
between the appliance and the cartridge, screw the new cartridge inside the appliance.
3. Never throw an empty cartridge into the fire.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kemper 1060RC at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kemper 1060RC in the language / languages: English, French, Italian as an attachment in your email.

The manual is 0.5 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info