771449

Kaysun KFC-S2-2T-250D Manual

5
Zoom out
Zoom in
Previous page
1/22
Next page
Controller installation place
Wired
controller
03
●Make sure that the water discharge pipeline can provide
smooth drainage. Improper installation of the water
discharge pipeline may lead to water leakage, and
damages to furniture.
●Make sure the liquid pipeline and air duct are reliably
supported. Make sure pipes and connectors are not
distorted.
●The water inlet and outlet pipes must have check valves
installed and be wrapped with insulation materials.
●Connect the wires as required. Otherwise, it may cause
damage to electrical parts.
●The actual power supply must be consistent with the
nominal nameplate value, or permanent damage may
occur.
●Use power cord with a proper diameter.
●Do not use damaged cables. Replace the damaged
cables immediately if necessary. Do not attempt to
repair the damaged cables.
●Keep for future reference.
2.4 Information
●Keep the unit serial number available for future
reference and in case when you need to contact the
after-sales service.
●Do not bring any combustible materials near the air
outlet.
●Transport the unit as per requirements indicated on the
package.
●Avoid crash, fall-over or squeeze and keep away from
rain and snow during transportation.
●Store the unit in a clean, dry, re-proof and well-
ventilated place without any corrosive gas.
●To avoid shock during transportation, x the unit and its
accessories on the transportation platform with ropes or
by other means.
3 OPERATION INSTRUCTIONS
This appliance can be used by children aged from 8 years
and above and persons with reduced physical, sensory or
mental capabilities or lack of experience and knowledge if
they have been given supervision or instruction concerning
use of the appliance in a safe way and understand the
hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by
children without supervision.
●The manufacturer is not responsible for unit damages or
personal injury resulting from unauthorized operations
or use of non-original parts or accessories.
●Ventilation
Periodically ventilate the room where the unit is
installed. Ventilation is especially important in case the
room has many people in it or has ammable devices
or gas sources. Poor ventilation may result in lack of
oxygen.
- Before unit operation, clean water pipes to prevent
them from being blocked.
- Upon FCU test run or switching between hot and cold
water, open the vent valve to exhaust air in the coil
until water ows out. Otherwise, the heat exchange
performance may be signicantly compromised.
●During operation
Filter is normally not removed except for maintenance
purpose, as doing so may cause foreign objects to enter
the unit.
●In normal cases
In cooling mode, fog may appear at the air outlet. Figure 3-2 After installation of wired controller
Figure 3-1 Installation position of wired controller
3.1 Standard Conditions for Use
Use the system in the following temperature for safe and
effective operation.
Mode Indoor temperature
Cooling 17-32°C
Heating 0-30°C
If air conditioner is used outside the above conditions,it
may cause the unit to function abnormally.Optimum
performance will be achieved within these operating
temperature range.
The unit can only operate normally as long as you
strictly adhere to the regulations outlined in the Manual.
Water inlet temperature range is 3-75°C.
Water inlet temperature range recommended is 3-65°C.
Water inlet pressure range is 0-1.6MPa.
3.2 Switch and Control
The wired controller should be purchased separately
from the manufacturer. Other wired controllers are not
applicable.
Installation position of wired controller
You can install the wired controller on the left, or right of
the unit or on the wall as required. Make sure the wired
controller is close to the electric control box.
Please refer to the Wired Controller Operation and
Installation Manual for installation methods.
… 5 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Kaysun KFC-S2-2T-250D at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Kaysun KFC-S2-2T-250D in the language / languages: English as an attachment in your email.

The manual is 1.62 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info