576231
47
Zoom out
Zoom in
Previous page
1/51
Next page
47 CA-EX70
ACTION
Connect the power.
Refer to “Connections” and
make sure all equipment is
connected correctly.
Connect the speaker cords.
Disconnect the
headphones.
Turn VOLUME to the right.
Make sure both speakers
are connected with the
correct polarity.
Adjust the balance toward
the center.
Make sure the speaker
cords are connected
securely.
Make sure the antennas are
connected securely.
Change the location and
direction of the AM loop
antenna.
Strech the wire antenna out
and pin it in a position that
provides good reception.
Replace the batteries.
Reinsert batteries correctly.
Point remote control at the
remote sensor on the
amplifier/tuner.
Keep the remote sensor
away from direct sunlight.
Additional Information
POSSIBLE CAUSE
The AC power cord is
disconnected.
Connections are incorrect or
incomplete.
The speaker cords are not
connected.
Headphones are connected.
The volume control is
turned all the way down.
The polarity (+, –) of one
speaker is reversed.
The balance is turned all the
way to the right or left.
A speaker cords is
disconnected.
Antenna is not connected.
The AM loop antenna is too
close to the unit.
The FM wire antenna is
laying in a pile on the floor.
Batteries are exhausted.
Battery polarity (+, –) is
reversed.
Incorrect operation.
The remote sensor is in
direct sunlight.
Troubleshooting
If you experience any difficulty with your units, check the following list for a possible solution before
calling for service. If you cannot solve the problem from the hints given here, or the units have been
physically damaged, call a qualified person, such as your dealer, for service.
SYMPTOM
Amplifier/tuner
Amplifier/tuner does not
respond.
No sound.
Sound placement and/or
motion is undefined.
Sound comes from only one
speaker.
Noise in broadcast signal
makes it difficult to hear.
Remote control does not work
EN40-52.CA-EX70[J]/1-5/21 98.6.9, 9:31 AM47
47


Need help? Post your question in this forum.

Forumrules
1

Forum

jvc-rx-ex70

Reset search

  • what is the purpose of the compu link by synchhrp, please Submitted on 17-1-2021 at 12:38

    Reply Report abuse


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JVC RX-EX70 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JVC RX-EX70 in the language / languages: English as an attachment in your email.

The manual is 0,8 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info