614573
3
Zoom out
Zoom in
Previous page
1/32
Next page
重要保护措施 重要安全提示
使用本机器时,应遵守基本的安全防护措施,包括下列各项:
使用前请仔细阅读所有说明书。
危险——减少电击的可能性
1.  当接上电源时,机器必须有人照看。机器使用后以及清洁前,必须拔下电源插头。
2.  更换照明灯前必须拔下电源插头,并且使用相同规格的15W照明灯。
3.  更换灯泡时务必拔掉插座。更换相同型号的3W 12V的灯泡。
警告——减少灼伤、火灾、电击或人身伤害
1.  本机器不允许被当作玩具,当儿童使用或靠近机器时,必须加以关注。
2.  本机器的功能仅限于本手册规定的范围之内,仅可使用本手册中生产厂商推荐的附件。
3.  发生以下情况时:机器电源线或插头损坏、机器工作不正常、机器被摔过或已损坏、或机器已进过
水,则绝对不可以使用机器。应将机器送到距离最近的授权销售商或售后服务中心作检查、修理及电
气或机械的微调。
4.  空气出口被堵塞时,绝对不可以使用机器。应保持缝纫机的通风,并且保持脚踏控制器的清洁,防
止棉绒,灰尘和零布的堆积。
5.  手指应远离运动的部件,机针周围应特别注意。
6.  应保证使用合适的针板。使用不适当的针板会引起机针折断。
7.  不要使用弯曲的机针。
8.  缝纫时不要推或拉布料,否则会引起机针折断。
9. 微调穿线穿线或更
“0”位。
10. 当机器卸下外壳、加油或进行使用手册中规定的保养或微调工作时,必须拔下电源插头。
11. 机器开口处绝对不能扔进或插入任何物体。
12. 不要在户外使用机器。
13. 正使用喷雾产品或充满氧气的地方禁止使用机器。
14. 如欲切断电源,须先将所有控制器微调到“0”位,然后拔下插头。
不要拉住电线拔插头。拔插头应抓住插头,而不是电线。
“记住这些说明”
本机仅限于家庭使用。
请使用下列脚踏控速器:
缝纫机型号 使用的脚踏控速器型号
TL-98P YC-485
2
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki TL-98P at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki TL-98P in the language / languages: English as an attachment in your email.

The manual is 7,98 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info