614565
28
Zoom out
Zoom in
Previous page
1/28
Next page
27
Troubles and Corrective Measures
If sewing difculties occur, make sure the instructions are correctly followed. If a problem still exists, the reminders below
help to solve it.
Troubles Case Corrective measures Page
Stitches are
skipped.
1. The needle is bent or the needle point
is blunted.
2. The needle has not been attached to
the needle bar properly.
· Replace the needle.
· Attach the needle properly to the needle bar.
26
26
Needle thread
breaks.
1. The machine head has been threaded
incorrectly.
2. The needle thread tension is too high
or low.
3. The needle is bent or the needle point
is blunted.
4. The needle is not suited to the thread
used.
· Correct the threading.
· Properly adjust the thread tension.
· Replace the needle.
· Replace the needle by the one suited to the
thread used.
23
24
26
26
The bobbin
thread breaks.
1. The bobbin thread tension is too high.
2. The rubbing of the bobbin case spring
has produced a slot.
3. Scratches on the needle hole in the
throat plate.
· Decrease the tension.
· Replace the bobbin case.
· Replace the throat plate.
24
-
-
The needle
breaks.
1. The needle is bent or has been
installed improperly.
2. The needle hits the throat plate or the
presser foot.
· Replace or correctly attach the needle.
· Correctly position the needle, throat plate, or
presser foot.
26
-
Stitches are
puckered.
1. The tension of the needle thread is
not balanced with that of the bobbin
thread.
2. When the combination of the needle
and the thread is improper.
3. The needle is too thick for the material.
· Balance the tension.
· Properly correct the combination of needle
and the thread.
· Replace the needle by the one suited to the
material.
24
25
25
Stitch
performance
is bad.
1. The tension of the needle thread is
not balanced with that of the bobbin
thread.
· Balance the tensions. 24
The rotation noise
is too heavy or
too high.
1. Thread wastes accumulate in the
hook.
· Clean up the sewing machine. 27
The handwheel
does not rotate
smoothly or does
not turn.
1. The thread is entangled and caught in
the hook.
· Lubricate the hook, strongly turn the
handwheel clockwise and counterclockwise
several times, then remove the thread
caught in the hook.
-
The sewing
machine cannot
perform sewing at
the beginning of
sewing.
1. Remaining length of thread is shorter.
2. Back tacking has not been carried out.
· Loosen the tension controller No. 1 (turn to
the left) to increase the remaining length of
thread after automatic thread trimming.
· Draw thread through the needle eyelet to
adjust the remaining length of thread to
approximately 5 cm.
· Be sure to carry out back tacking by several
stitches at the beginning of sewing.
25
-
25
28


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Juki TL-2200QVP at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Juki TL-2200QVP in the language / languages: English as an attachment in your email.

The manual is 2,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Juki TL-2200QVP

Juki TL-2200QVP User Manual - German - 28 pages

Juki TL-2200QVP User Manual - Dutch - 28 pages

Juki TL-2200QVP User Manual - French - 28 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info