28356
96
Zoom out
Zoom in
Previous page
1/148
Next page
95
Section 3 Operation
HDOP LEVEL (Setting the HDOP level)
•In this menu, you can set the upper limit of the HDOP level using
this item. The HDOP level indicates the geodetic precision
determined by the constellation of the GPS satellites. Precision is
increased as this level decreases and vice versa. The constellation of the
GPS satellites changes constantly and the HDOP level changes
accordingly. The GPS/DGPS sensor stops positioning when the
HDOP level exceeds the upper level specified in this item. Therefore,
if you set a smaller value as the upper limit, the precision is improved,
but the possibility of interrupting positioning becomes larger.
AVERAGE (Setting an interval to average the data)
•In this menu, you can set an interval to average the positioning data.
If you set a longer interval, the positioning data becomes more stable.
If you set a shorter interval, you can reflect your vessels movement
changes more quickly, though the positioning data becomes less
stable.
EXCLUDE SAT (Setting the satellite number not
used)
•In this menu, you can set the satellite numbers so that excluded
satellites are not used for positioning. The GPS/DGPS sensor does
not use these excluded satellites for positioning.
The satellite number not used cannot be set by GPS112/DGPS212
themselves.
DGPS SETTING
•In this menu, you can perform the basic settings of the beacon
module of the DGPS sensor.
Note:
•Use TX COMMAND to send the values set in the following settings.
MODE (Setting the reception mode of the beacon)
•In this menu, you can set the reception mode of the beacon.
FREQUENCY (Setting the beacon frequency)
•In this menu, you can set the beacon frequency. The frequencies range
from 283.5 kHz to 325.5 kHz and you can set it in increments of 0.5
kHz.
BAUDRATE (Setting the beacon baud rate)
•In this menu, you can set the baud rate used by the beacon.
DGPS SETTING
AUTO
283.5KHZ
100BPS
MODE
FREQUENCY
BAUDRATE
TX COMMAND
96


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JRC Radar1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JRC Radar1800 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info