28356
33
Zoom out
Zoom in
Previous page
1/148
Next page
Section 2 Installation
32
Figure 2-7 Belt Fitting Method
Belt fitting method
ATTENTION
Do not fasten the junction of connectors with the
fitting belt.
It may cause connector damage.
Do not coil the fitting belt around the aluminum base.
The aluminum base will be scratched with the belt
and may cause corrosion.
GPS/DGPS
Sensor
Do not coil the fitting
belt around the
aluminum base.
Cable
20mm
(Sensor case bottom
to Mast top)
Plastic
Mounting
Unit
Fitting belt
Mast
(ø26- ø50)
1. Loosen the fitting belt screw
with a screwdriver and
remove the clamp.
Clamp
Minus screw driver
2. Coil the fitting belt around
the mast as shown below.
3. Tighten the clamp screw
with a screwdriver.
33


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JRC Radar1800 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JRC Radar1800 in the language / languages: English as an attachment in your email.

The manual is 2,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info