553862
11
Zoom out
Zoom in
Previous page
1/12
Next page
E-2120-E
-To start using the device you must place the switch On/Off in
position I. The button on the control panel is used only as
'Stand by ' of the device, not for disconnection
!" #"! #!
  """
-Make sure that the on/off switch is in O position before plugging
it from the mains.
- To fill the water deposit, lift the cap on the top of the device and
fill with water through any of the departments, till the water level
indicator overcomes
(“”)
(fig.2).
 "" never overcome maximum water level, H&I
Capacity:9L.
-To empty the water deposit, open the cap on the bottom of the
device (between the two back wheels). See cleaning section.
%  the deposit could have up to 9 litres of water, even if
the level indicator shows minimum
(“”)
.
"!" ""$
Connect the device to power supply.
Press the lateral button «k» (On/Off) to switch it on and put it in
position I.
Select the position of cold or warm air with the lateral temperatu-
re selector «L».
Now the device is ready to work, to activate the device press the
button I/0 on the control panel and the device will start operating.
Select the output speed of air you want, the button (5). You
can select three positions:
«I» - low air flow.
«II» - medium air flow.
«III» - maximum air flow.
Press the button to select the desired position.
Button (1). It is used to set the operation time of the device.
When the time is out the device will be automatically disconnec-
ted. To program it, simply press the button . Each time you
press this button increases the set time a half hour to a total of
seven hours. The lights indicate the scheduled time.
Wind blow mode (4): To select the Wind blow mode of the
device you have to press the key . With this function the air
varies in intensity and direction gradually. If you want the tabs
stay in a certain position, when they are in the desired position,
press the button Wind blow again and the position will be
fixed.
Cold mode: button (3). To get cooler and humid air place ice
in the largest compartment located at the top of the device (e) or
into the lateral water containers (f) and press . With the light
on it also purifies the air, if the light is off, only cool dry air is
coming out.
Heat Mode: place the temperature selector to the heat position
and press the button (2). The hot air will come out.
Function Mode (6): to select the type of wind blow you have
to press the button . There are three types of wind blowing:
sleep mode, natural and normal. Select the desired one.
Remote control: controls the same functions of the device on the
distance of 5 meters.
Unplug the device when you finished using it.
!" 
-Before cleaning the fridge, make sure the device is not plugged
in the current and the water/ice tank is empty.
- To empty the water tank in case of excess of the water or to
clean the device, open the drain plug in the lower back part, to
remove it turn the plug counter clockwise until it is separated from
the device, pull the rubber stopper and drain the water.
Once all the water is out, place the rubber stopper and drain plug
again.
-Please clean the water tank from time to time.
-The filter should be cleaned with a damp cloth approximately
every 15 days.
!9-6895*-9)2-495+0)4/-90-.139-7
1.- Take the grid out of the filter with the help of a screwdriver.
2.- Take the filter out of its deposit and shake well to clean.
3.- If the filter is too dirty, put it in a bowl with water and neutral
soap.
MODE
MODE
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jocca 5892 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jocca 5892 in the language / languages: English, Portuguese, Spanish as an attachment in your email.

The manual is 1,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info