Technical Information
Caution: DO NOT attempt to wash the glass bowl or lid until they cool down to
room temperature. If cold water is poured on the glass while it is still hot, it could
crack or break the glass.
Self-cleaning - ‘Wash’
The Halogen Oven has a special self-cleaning setting ‘Wash’ on the temperature control,
which should be used to wash the glass bowl:
1. Remove any food and drain away any fat from the glass bowl.
2. Allow the Halogen Oven to cool.
3. Add approximately 1.5cm of cold water into the glass bowl with a squirt of washing up
liquid. Replace the glass lid and turn the temperature control to ‘Wash’.
4. Set the time control to 10 - 15 minutes, depending on how dirty the glass bowl is.
The combination of the heat, the swirling motion caused by the fan and the washing up
liquid will clean the glass bowl quickly and efficiently.
The cooking racks can be left in the glass bowl when cleaning to soften any stuck on
deposits.
5. Allow the Halogen Oven to cool.
6. You may need to use a washing up brush to remove stubborn deposits before rinsing
and wiping dry.
General Cleaning and Care
Before cleaning ensure the Halogen Oven is turned off, unplugged from the mains and cool.
All parts, EXCEPT the glass lid and the plastic base are dishwasher safe.
DO NOT use abrasive cleaners or scouring pads on the metal or plastic surfaces.
The outer surface of the glass lid should only be wiped clean with a damp cloth.
Warning: When hot, do not place the glass lid on or close to any flammable or combustible
items. It may cause fire or explosion.
Cleaning & Care
Guarantee
Technical Information
Glass bowl external diameter 33cm
Glass bowl internal depth 16cm
Glass bowl volume 12 Litres
Power consumption 1300W
Power supply 220-240V~50Hz AC
Fuse & mains plug replacement (UK & Ireland only)
This appliance is fitted with a BS 1363 13-amp plug. If you have to replace the fuse, only use
those that are ASTA or BSI approved to BS 1362 and with a rated current of 13 amps.
Should you need to replace the plug; the wires in the power cord are coloured in the
following way:
Blue – Neutral Brown – Live Green & Yellow – Earth
As the colours of the wires in the power cord may not correspond with the coloured
markings identifying the terminals in your plug, and proceed as follows:
The wire that is coloured green & yellow must be
connected to the terminal in the plug that is marked
with the letter E or by the earth symbol .
The wire that is coloured blue must be connected to
the terminal that is marked with the letter N.
The wire that is coloured brown must be connected
to the terminal that is marked with the letter L.
If the power lead is damaged, it must be replaced
by a qualified electrician.
9 10
This product is unconditionally guaranteed for one year against all defects of workmanship
and materials. This guarantee does not affect your statutory rights. If you have any problems
or queries about this product please contact JML.
JML Customer Helpline: 0800 781 7831
Disposal and the environment
This product is covered by the waste electrical and electronic equipment
(WEEE) regulations. It should not be discarded with normal household waste,
but taken to your local collection centre for recycling. For further information,
please contact the local authority or approved disposal agency.
