415145
5
Zoom out
Zoom in
Previous page
1/8
Next page
If only an 8-ohm rating is given, the
amp/receiver may or may not be
designed to handle 4-ohm combined
ratings. Consult the owner’s manual
of the amp/receiver for clarification.
POWER HANDLING
Thanks to their high efficiency, the
JBL MR Series Loudspeakers will
produce reasonable volume levels in
a room of moderate size with very lit-
tle amplifier power. However, using a
small amplifier to obtain the desired
volume listening levels may lead to
overdriving the amplifier. This will
generate high distortion levels and
may cause damage to your loud-
speaker. For the best performance,
an amplifier should be selected with
an output rating that is greater than
the maximum power that will be
used. This margin of reserve power
will ensure that the amplifier will not
attempt to deliver more power than
its design allows. However, the
amplifier’s power rating per channel
must not exceed the maximum rec-
ommended amplifier power for that
specific loudspeaker model. Please
see the specification section for
details. Following these guidelines
will provide virtually distortion-free
sound reproduction and long loud-
speaker life.
TROUBLESHOOTING
The vast majority of new speaker
“malfunctions” end up being traced to
connections or switch settings. To
avoid packing up correctly functioning
speakers and sending them off, only
to find that they’re not really at fault,
check the following tips first, before
requesting service.
No sound at all or very faint sound
from both speakers
1. Amp/receiver tape monitor button
pushed in while using CD, FM or
phono inputs.
2. Wrong speaker switch, “A” or “B”
speaker output.
3. Sound source (CD,cassette deck,
turntable) not turned on, not activat-
ed, not hooked up or not selected on
amp/receiver front panel.
No sound from one speaker
1. Balance control turned all the way
left or right.
2. Speaker wire has become discon-
nected.
3. One of the connections between
sound source and amp/receiver is
faulty or has become disconnected.
Both speakers play at low volumes
but shut off as volume is in-
creased OR sound turns on and
off intermittently
A few strands of speaker wire may
be shorting out. Recheck the con-
nections. Recheck the impedance of
the amp.
Bass is very weak AND/OR sound
seems to come from each speaker
separately, without creating a
stable stereo image between the
speakers.
1. The polarity (+ & –) of one speaker
has been reversed relative to the
other. Double check connections.
2. Speakers are too far away from
back and side walls or too far apart.
Experiment again with the speaker
placement. If you are still encounter-
ing problems, consult your JBL
dealer.
Additional Areas to Check When
Using an AV Receiver:
No sound at all or very faint sound
from the center channel or other
speakers
1. Speaker wire has become discon-
nected.
MR SERIES LOUDSPEAKERS
5
MR Series OM 7/28/98 10:32 AM Page 5
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL mr 28 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL mr 28 in the language / languages: English as an attachment in your email.

The manual is 0,05 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info