648488
10
Zoom out
Zoom in
Previous page
1/16
Next page
7
Use a small Phillips screwdriver to loosen the adapter’s set screws and insert the speaker wires into the holes on the back of the adapter.
Tighten the set screws to secure the wires.
Always connect the (+) speaker wire to the adapter’s (+) terminal and the (–) speaker wire to the adapter’s (–) terminal. When all wires are
connected, plug the adapters into the Club amplifier’s FRONT (and REAR, if using the 4-channel amplifier) preamp inputs.
Remote: Connect a 20-gauge wire from the “Remote Out” lead of the source unit to the REM input. This lead turns the amplifier on when
using low-level input signals.
Ground: Run a wire (the same gauge as the power wire) from the GND input to a factory bolt in the vehicle’s chassis (see illustration below).
NOTE: Remove any paint from the chassis for best contact. Use a star washer below the ring connector for a secure connection.
6. Front and rear inputs and outputs (RCA):
If your source unit offers preamp outputs, connect to the FRONT, REAR, and/or SUB inputs using RCA patch cables.
To connect a second amp directly to the Club-704 amplifier, run a patch cable from the PRE OUT outputs to the second amp’s preamp inputs.
If your car audio system’s head unit does not have line-level outputs:
Use the supplied bare wire-to-RCA adapters to connect the Club amplifier’s inputs to either the front or the rear speaker outputs of your car
audio system’s head unit (splice crimps not included).
Important: Some factory-installed audio system amplifiers include electronic filters that limit the amount of bass sent to the system’s smaller
speakers. This filtering will adversely affect the Club amp’s performance. To get the most bass possible from your Club amp, splice the bare
wire-to-RCA adapters into the factory system speaker outputs that are connected to the system’s largest speakers (the ones designed to make
the most bass).
Factory Bolt
Ring Connector
Ground Wire
Note: Remove any paint
below ring connector
Star Washer
Loosen
Screws
Insert
Wires
Tighten
Screws
10


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for JBL Club-4505 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of JBL Club-4505 in the language / languages: English as an attachment in your email.

The manual is 1,72 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info