616096
6
Zoom out
Zoom in
Previous page
1/9
Next page
6
Congratulations on your purchase of
J
amo Indoor/Outdoor speakers.
P
ackage content.
Speaker (2) Port plug “i” (4) Allen wrench (1)
Assembled bracket (2) Thumb screw “j” (4) Manual (1)
Screw plug “g” (8) Covers “k” (4)
B
racket.
The brackets comes pre-assembled. If disassembling the bracket for paint-
ing, re-assemble it as follow: Place the curved bracket (a) between the wall
bracket (b) and wall bracket cover (c) as shown in fig. 1. Insert two 1” allen
bolts (d) through wall bracket into wall bracket cover and tighten with the
supplied allen wrench. Insert two ½” allen bolts (e) into each side of wall
bracket and tighten towards curved bracket.
M
ounting of bracket.
The bracket can be mounted for horizontal or vertical placement of the
speaker. Mount the bracket with four screws (not included) appropriate for
the surface the bracket is mounted to (wood, brick, concrete or other). Take
into account the weight of the speaker (specications on back). A hole (f) in
the middle of the bracket allows for running the speaker wire through the
bracket if so desired. Cover the screws with four screw plugs (g) fig. 2.
M
ounting of port plugs.
If the front of the speaker is exposed to rain directly entering the bass reex
ports (under the grill), the ports should be closed to avoid lling the
speaker with water. High moisture is not a problem. Remove the grill (h)
from the speaker and insert two port plugs (i) into the bass ports. Re-install
the grill. The speaker will reproduce less bass with the ports closed.
Fig. 1
b
c
d
e
a
d
e
f
Toutes nos félicitations pour avoir acheté ces
enceintes Jamo pour usage intérieur et extérieur
Contenu de l’emballage
Enceintes (2) Porte-prises “i” (4) Clé hexagonale (1)
Support assemblé (2) Vis à serrage “j” (4) Manuel (1)
Cache vis g” (8) Cache “k (4)
Support
Le support est livré pré-assemblé. Si le support est démonté pour être peint, il faut le réassem-
bler en suivant cette procédure : placez le support courbé (a) entre les supports muraux (b) et le
cache support (c) comme montré dans la gure. 1. Insérez deux boulons à tête creuse hexago-
nale de 1 pouce (d) à travers le support mural, dans le cache du support mural et serrez avec la
clé hexagonale. Insérez deux boulons à tête creuse hexagonale de ½ pouce (e) de chaque côté
du support mural, et serrez pour xer le support courbé.
Fixation du support
Le support peut être xé de manière à y placer une enceinte à l’horizontale ou à la verticale.
Utilisez quatre vis (non incluses) appropriées à la surface à laquelle le support est xé (bois,
brique, béton ou autre). Il faut tenir compte du poids de l’enceinte (spécications au dos). Le
trou (f) au milieu du
support permet de faire passer les ls de l’enceinte si c’est nécessaire.
Couvrez les vis à l’aide de quatre caches vis (g) g. 2.
Fixation du porte-prises
Si lavant de l’enceinte est exposé directement à la pluie menant aux évents de résonance
(sous la grille), les ports doivent être bouchés pour éviter l’inondation des haut-parleurs. Une
grande humidité est sans eet. Retirez la grille (h) de lenceinte et insérez deux porte-prises (i)
les évents des graves. Remettez la grille. Lenceinte émettra moins de graves si les ports sont
fermés.
Fig. 1
6


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jamo 3A2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jamo 3A2 in the language / languages: English, French as an attachment in your email.

The manual is 0,47 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info