554979
2
Zoom out
Zoom in
Previous page
1/2
Next page
GSM car alarm CA-1802A „Athos“ 2/2 MHF58501
Internet remote access
The web site www.GSMLink.cz enables car alarm remote control
(to users) and setting (to installers).
To get internet access to an installed and powered car alarm you will
first be asked to register your car alarm on the first page. You will find
a unique registration code for your car alarm on the warranty card.
Additional features
1. Pre-paid SIM card balance
It is recommended not to use prepaid cards in the car alarm. If you
have no other choice than prepaid cards, you can enable the CREDIT
instruction by the following sequence:
MASTER CREDIT uuu..u xx yyy zz
where: uuu…u is the provider’s code to obtain the balance
xx is the time period (in days) for regular checking
yyy is the threshold level below which the balance is
reported to the user (TEL1)
zz is the position of the first digit of the balance in the
reply SMS from the provider
After this sequence has been sent once, the car alarm will check the
balance automatically every xx days and if the balance is lower than yyy
the user will be notified (TEL1)
If the CREDIT instruction is enabled in the above way, the user can also
obtain the current balance by the instruction CREDIT
To disable the automatic balance checking set the time period “xx” to 00.
2. Reset GSM
If you need to disconnect and then reconnect the GSM module to the
GSM network, then use the command “MASTER RESET GSM”.
This does not affect any settings and is typically used for GPRS
activation or charging up credit. This command always requires the
Master code.
3. Service instruction
The DINFO instruction allows you to obtain current settings,
information about the quality of the GSM signal, the registration code
for GSMLink devices and some other parameters. This command
always requires the Master code.
Example of instruction: MASTER DINFO
Example of response: Car alarm reports: CA-1802A, SN:123456,
SV:01, LV:03, RK:ABCDE-12345-FG67, R:01, GSM:25, Time:3.2.06
11:35
CA-1802A car alarm version
SN:123456 identification number of the product
SV:01 software version
LV:03 language version
RK: ABCDE-12345-FG67 registration code for GSMLink
R:01 current Reset mode of the device
GSM:25 instant quality of GSM signal (ranging from 0 to 32 (best))
Specification
Power supply 12/24V DC (8-32V)
Stand-by consumption max. 20 mA
Immobilization 8A permanently, 12A intermittently
Complies with ECE Regulation No. 97.00
Can be operated according to ERC/DEC98(20,21), ERC REC 70-03
Safety EN 60950-1
EMC EN 55022, EN 50130-4
Radio interference ETSI EN 301 419-1, EN 301 511, ETSI EN 300 220
ETSI EN 300 328
JABLOTRON ALARMS a.s. hereby declares that the CA-1802 is in
compliance with the essential requirements and other relevant
provisions of Directive
1999/5/EC and 1995/56/EC The original of
the conformity assessment can be found at www.jablotron.com
,
Technical Support section
Note: Although this product does not contain any harmful materials we
suggest you return the product to the dealer or directly to the producer
after use.
97 RAI-01 4532
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Jablotron CA-1802 Athos at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Jablotron CA-1802 Athos in the language / languages: English as an attachment in your email.

The manual is 0,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Jablotron CA-1802 Athos

Jablotron CA-1802 Athos User Manual - English - 16 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info