578887
1
Zoom out
Zoom in
Previous page
1/2
Next page
ORBIT 2 - Radio controlled clock with Silent Mode
HOW TO OPERATE
1- To start the clock
Insert the battery into the battery compartment in the indicated polarity. The clock will start to receive the
time signal DCF77 automatically.
2- Time signal reception mode
a) Automatic reception mode
- The time reception will start after inserting the battery
- Twice a day the clock will synchronize the time
b) Manual mode
- A time signal reception can be started by pressing the WAVE button for 3 seconds.
After starting a full reception, the seconds, minutes and hours hands will move to the 12 o'clock position and
remain there as long as the reception takes place. A full reception may take 3-10 minutes.
Upon completion of a successful reception, the clock will move the hands to the exact time and continue to
operate as a clock. Should there be no good reception, the clock will start working from the 12 o'clock
position. In this case, you may adjust the time manually.
3- Manual time setting mode
Press and hold the SET button. Now you have entered the manual time setting mode and the minutes hand
will keep moving forward for as long as you press the SET button. The clock will exit form the time setting
mode if you do not press the SET key for more than 6 seconds and continue to operate as a clock.
4- Reset
On rare occasions the clock may not respond when pressing buttons or well functioning. In this case, you
need to reset the clock by pressing the RESET button at the backside of the clock. By doing this, the clock
will start-up newly in the same way as described above after inserting a new battery.
5- To set alarm, light, Electronic light and snooze features
Turn the knob on the backside counter-clockwise to set the alarm hand at the desired time.
Then, set the alarm ON/OFF switch on ON position.
When the alarm time is reached, the alarm will sound 2 minutes with increasing intensity. To interrupt the
alarm, please read below in section "7-Snooze".
6- Silent mode (to avoid any noise from the clock movement)
The silent mode is enabled by setting the alarm ON/OFF switch on the rear of the clock to the ''ON'' position.
The seconds hand will then move to the 12 o'clock position and remain there until the switch is moved to the
OFF position again. Upon activating/deactivating the silent mode, you may have to wait up to one minute to
see the seconds hand stop or move again.
7- Snooze
a) Manual
During the 2 minute alarm sound, you may press Snooze (button at the backside above the Alarm ON/OFF
switch). The alarm will then be interrupted for 4-5 minutes and then sound again. You may repeat such
Snooze cycles within 40 minutes of the initial alarm time. After this, the clock will stop and, if the alarm is left
"ON", sound again at the set time 12 hours later.
b) Automatic
If no key is pressed during the 2 minutes alarm sound, then the alarm will be repeated after 5 minutes
automatically ( there are totally two 2 such automatic repetitions if no key is pressed). After this, the clock will
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Irox ORBIT 2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Irox ORBIT 2 in the language / languages: English as an attachment in your email.

The manual is 0,04 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Irox ORBIT 2

Irox ORBIT 2 User Manual - German - 2 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info