585389

Irox HBR555t Manual

22
Zoom out
Zoom in
Previous page
1/24
Next page
70 71
6968
4c) MAXIMUM AND MINIMUM
TEMPERATURES AND HUMIDITY
The maximum and minimum recorded indoor temperature,
humidity and outdoor temperatures will be automatically
stored in memory. To display them, Press [ MEM ] once
to display the maximum readings and again the minimum
readings. The respective indicators,
[ MAX ] or [ MIN ] will be displayed.
To clear the memory, hold down [ MEM ] for two seconds.
The maximum and minimum readings will be erased.
If you press [ MEM ] now, the maximum and minimum
readings will have the same values as the current ones until
different readings are recorded.
4d) TEMPERATURE ALARM
Weather Station is equipped with a temperature alarm
whereby a user-defined temperature can be selected.
When the selected temperature is reached an acoustic alarm
will be initiated. Temperature alarm is programmed as
follows:
1. Press the [TEMP ALARM] button.
2. Hold the [TEMP ALARM] button for 2 seconds.
3. Select the desired temperature for the alarm by using the
[ ] or [ ] buttons.
With one further pressing of the TEMP ALARM button
the data entered is confirmed.
4. THERMOMETER / HUMIDITY
4a) HOW TO CHECK REMOTE AND
INDOOR TEMPERATURES
The wave display on the outdoors temperature indicates the
reception of the remote unit is in good order. If no readings
are received from the remote unit for more than two minutes,
blanks “ ” will be displayed until further readings are
successfully searched. Check the remote unit is sound and
secure. You can wait for a little while or Hold [ ] for 2
seconds to enforce an immediate search. If the temperature or
humidity goes above or below than the measuring range of
the main unit or the remote unit (stated in specification), the
display will show “ ” & “HHH” or “LLL” respectively.
The unit can be set to automatically scan and display
readings from the remote sensors, the display will show
the readings from one channel for about 4-seconds and
then proceed to the next channel display.
-To activate the remote-sensor scanning mode:
Press and the hold the button [CHANNEL] for 2 seconds.
-To deactivate the remote-sensor scanning mode:
Press and the hold the button [CHANNEL] for 2 seconds.
3b) BAROMETRIC PRESSURE TREND
The atmospheric pressure indicator, in the weather forecast
window, uses arrows to indicate if the atmospheric
pressure is increasing, remaining stable, or decreasing.
3. WEATHER FORECAST
3a) WEATHER FORECAST
The unit is capable of detecting atmospheric pressure
changes. Based on collected data, it can predict the weather
for the forthcoming 12 to 24 hours.
3b) Weather Forecast Alert
A weather forecast alert alarm will go on when the
weather forecast change to one of the status below:
Heavy rain, heavy snowy or unstable stormy weather.
The Weather Display backlight will be lighting up 2
minutes, the beep sound turns on and the storm symbol
will be shown on the display. To deactivate the
sound alert switch the [ALERT] button to “OFF”.
Arrow
indicator
Pressure
Trend
Steady FallingRising
NOTE:
1. It is not necessary and not possible to adjust the altitude
of the weather station. After the initial start-up of the
weather station, a first forecast will be made within the
first 24 hours of operation.
2. In periods of long stable weather conditions, it becomes
difficult to make a reliable forecast.
3. The weather forecast is solely calculated on the basis
of barometric air pressure changes.
4. The probability of a correct weather forecast is
approximately 70% and is valid for an area of approx.
20-30 km around the location of the weather station.
5. The forecast “Sunny” means at night “cloudless
weather”. Fogies not indicated by the weather station
as this can occur with different weather conditions.
6. If you travel with become impossible due to changes in
altitude and location. You'll have to wait up to 24 hour
so that the weather station can calculate a new forecast
based on the conditions at the new location.
Forecast
Symbols
Sunny Slightly Cloudy Cloudy
Snowy heavy snowyHeavy rainyLittle rainy
The unit is in searching mode.
Temperature readings are
securely registered.
No signals.
˚C
4b) HOW TO READ THE KINETIC WAVE DISPLAY
The kinetic wave display shows the signal receiving
status of the main unit. There are three possible forms:
… 22


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Irox HBR555t at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Irox HBR555t in the language / languages: English, German, French, Italian as an attachment in your email.

The manual is 4,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info