578600
54
Zoom out
Zoom in
Previous page
1/60
Next page
ENG
54
How to connect the outside sensors
When putting into operation the station or after changing the batteries at the
main station or one of the sensors the following steps have to be proceeded to
connect the station with the sensors.
1. Open the battery compartment on all outside sensors.
2. Press “Reset“ on each sensor.
If you like to change the cannel press “CH” right after pressing “Reset” on
the sensor. Now place the sensors in 1m distance to the main station.
3. Now press “Reset” on the main station. This has to be done in-between 1
minute since pressing the rst time Reset on an outside sensor.
4. Wait for 5 minutes until the main station has found the outside sensors
and nished the starting procedure.
5. Place the outside sensor on the preferred place
DCF 77 RADIO CONTROLLED CLOCK
The built-in radio controlled clock is designed to synchronize the time
automatically once the unit is brought within the range of the Frankfurt DCF
77 radio signal. When the unit is receiving the signal, the radio reception “
”. icon will start ashing and during this reception all manual settings are
disabled.
The time reception may take, depending on the signal strength, up to 10
minutes.
When the time reception is complete, the “ ” icon will stop blinking and the
following result is shown.
: Last reception was successful
: Last reception was not successful
Please note:
The radio controlled clock will start to receive the time automatically in the
early morning hours.
To switch off the radio controlled clock, please refer to point 9 of next section.
54


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Irox EBR707C at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Irox EBR707C in the language / languages: English, French, Italian as an attachment in your email.

The manual is 0,7 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info