Manual Inventum HK10B (page 24 of 28) (English, German, Dutch, French)

54734

Zoom out

Zoom in

1/28

• The complete drawer is made out of two parts. The

top is the holder for the multi-padholder and the

bottom is the coffee-outlet. To clean the two

thoroughly, you can take it apart.

• At the backside there is a clamp, holding the

holder

on the drawer. You can pull the clamp gently

backwards until you can pull the

holder upwards.

Remove the complete

holder from the drawer.

• To replace the

holder on the drawer, you should place

the supports at the front of the holder in the recesses

at the top of the drawer. Than you can push back the

holder until the clamp snaps in place.

• Clean the separate parts: the

multi-padholder

13, the

cremamaker

14, the drawer 10,

the grid 7 and the driptray 8 with

warm water and some washing-up

liquid or in the dishwasher and

make sure that the parts are

dry before next use.

• Pay attention to clogging the

small drains in the middle of the padholder 13 and the

outside of the cremamaker 14. Remove the

cremamaker 14 by pushing it out, from below, with a

blunt object like a pen or the back of a teaspoon. This

also concerns the teamaker in the teapadholder 15.

• Check every day if the driptray 8 is empty and there

are no used coffeepads in the appliance. If the driptray

is full, it will overow and the liquid will ow under

the appliance.

We advise to descale your coffeepadmachine on a regular

bases. The period depends on the condition of your

water and the frequency of use. We advise to descale the

coffeepadmachine approx. every three months. You can

use a special descalingproduct for coffeemachines.

When you use a descalingproduct especially for

coffeemachines, you will have to follow the instructions

on the package of the descalingproduct accordingly.

• Switch off the coffeepadmachine with the on/off

button.

• Fill the reservoir according the instructions on the

package of the descalingproduct.

• Place a large mug or bowl under the coffee-outlet to

collect the descalingmixture.

• Open the drawer for the coffeepadholder by pulling the

handle on the side of the drawer outwards gently. The

drawer will now slide open.

• Place a new or used coffeepad in the multi-padholder

with the bulging side down and press it lightly. The

coffeepadmachine will be better descaled when you do

this and it cannot be clogged with descalingbits.

• Slide the drawer gently inwards until it can’t go further.

• Switch the coffeepadmachine on with the -button and

press

directly the 1-cup - button and 2-cups -

button at the same time. Do not let the machine heat

up.

• The coffeepadmachine will now rinse with the

CLEANING SEPARATE PARTS

DESCALING

descalingmixture.

• The coffeepadmachine will automatically switch itself

off when the rinsingprocess is ended. Repeat the

process until the waterreservoir is empty. After the

descaling you will have to rinse the machine upto

3 times with 1 liter of fresh cold water to make sure

that there is no descalingproduct left behind in the

coffeepadmachine to avoid a bad taste to the coffee.

Attention! If you haven’t used the coffeepadmachine for

a while, for instance if you have been away on a holiday,

you should remove all the separate parts for cleaning and

rinse the coffeepadmachine with fresh water. Place the

cleaned parts in the machine. This prevents an additional

taste.

When the appliance has a malfunction, one or two pilot

lamps will blink fast.

Lamp Color Condition Explanation

6.1/6.2 red/

green

constantly Coffeepadmachine is

ready for use.

6.1 red blinking

slowly

Appliance is heating

up.

6.1 red blinking

fast

Malfunction in the ap-

pliance, see the table

below.

6.2 green constantly Coffeepaddrawer is

locked correctly and

the appliance is ready

for making coffee.

6.2 green blinking

slowly

Don’t open the

drawer, it is still

locked. Please wait

a couple of seconds

until the pilot lamp

lights constantly.

6.2 off off Coffeepaddrawer is

not locked, open the

drawer and lock it

again.

Check the following steps to solve the malfunction

yourself.

Cause

Waterreservoir is not placed correctly

Solution

Empty the reservoir, ll it up again to the maximum-

level and place it on the coffeepadmachine.

Cause

Waterlevel is under the minimum

Solution

Fill the waterreservoir to the maximumlevel.

8 | SOLVING A MALFUNCTION

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Inventum HK10B in the language / languages: English, German, Dutch, French as an attachment in your email.

The manual is 2,43 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Inventum HK10B Manual

Product: