685028
4
Zoom out
Zoom in
Previous page
1/8
Next page
4
CARE AND MAINTENANCE
Cleaning the hob
Before cleaning the cooking hob, disconnect it from mains power
supply and wait until it has cooled down.
Important: never clean the appliance with steam cleaning equipment.
Wipe it with a cloth moistened with hot water and soap or diluted liquid
detergent.
Do not use abrasive or corrosive products, chlorine products or steel wool.
Do not leave acid or alkaline substances, such as vinegar, salt or lemon
juice, etc., on the cooking hob.
Stainless steel surface
Clean it with a specic commercial product.
Note: if the cooking hob is used continuously,the high temperatures
may alter the colour of the hotplates.
Cleaning the electric hotplates
The electric hotplates must be cleaned when they are lukewarm. Wipe
them with a cloth moistened with water and salt, and polish with a cloth
moistened with oil.
AFTER-SALES SERVICE
Before contacting After-sales Service:
1. Re-start the cooking hob, to check whether correct operation has been
restored.
2. If the malfunction persists, call the After-sales Service.
Give the following information:
type of malfunction;
model of cooking hob;
service number (i.e., the number that follows the word SERVICE on the
rating plate under the cooking hob and on the guarantee paper);
your complete address;
your telephone number and area code.
If any repairs are required, please contact an authorised After-sales Service
as indicated in the warranty. In the unlikely event that an operation or repair
is carried out by an unauthorised technician, always request a certication
of the job carried out and insist on the use of original spare parts. Failure
to comply with these instructions may compromise the safety and
quality of the product.
INSTALLATION
Technical information for installer
This cooking hob can be embedded in a worktop 20 to 50 mm thick.
If another appliance is not tted under the cooking hob, insert a separator
panel, at a distance of at least 90 mm from the cooking hob bottom.
If a vertical piece of furniture is installed, there must be a gap of at
least 100 mm between it and the edge of the cooking hob.
Installation of cooking hob
Apply the supplied gasket to the cooking hob (unless it has already
been tted), after having cleaned its surface as shown in the gure.
A - If the worktop is made out of wood, use the springs supplied.
1. Fit the 4 springs A into the relevant seat under the box.
2. Make an opening in the worktop, respecting the dimensions indicated in
the enclosed product description sheet.
3. Install the cooking hob in the worktop.
B- If the worktop is made out of marble or other materials (plastics, ceramics
or stone), the cooking hob must be xed by means of brackets B to be ordered
from the After-sales Service (code 4819 310 18528).
1. Align the brackets with the bores and x them with the screws.
2. Make an opening in the worktop, respecting the dimensions indicated in
the product description sheet.
3. Install the cooking hob in the worktop.
Before installing the cooking hob, remove the plastic lm that protects
it, if present. The outer surfaces of the furniture or appliances adjoining
the cooking hob must be heat resistant (heat protection “Y”, according to
standards EN 60335-2-6).
Installation must comply with current local safety regulations.
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Indesit TI 60X at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Indesit TI 60X in the language / languages: English as an attachment in your email.

The manual is 1,06 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Indesit TI 60X

Indesit TI 60X User Manual - German - 8 pages

Indesit TI 60X User Manual - Dutch - 8 pages

Indesit TI 60X User Manual - French - 8 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info