311702

Ignis awv 516 Manual

2
Zoom out
Zoom in
Previous page
1/2
Next page
5019 512 10017
Ignis is a registered trademark of Whirlpool USA.
Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized
conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the
table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy
Label” refer to the programme “Coloured Cotton 60°C”.
* The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household
conditions applicable at that time.
** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains
the water out.
1. Close the drum flaps and check that they are
properly locked.
2. Add detergents and additives into the dispenser
to no more than the
“MAX”
level mark, as
follows:
• Programme with pre and main wash
• Main wash programme without prewash
• Fabric softeners and conditioners
• Chlorine bleach
• Stain remover agents
• Anti-scale agents (if necessary)
3.
Turn the
programme selector knob
clockwise
to the desired programme.
4.
Turn the
temperature knob
to the required
temperature.
“Eco Wash” button
• The wash time is extended and the water
temperature is reduced.
• This function saves about 30% in energy without
compromising the excellent results of the wash.
“Half Load” button
• Reduces the water consumption in the “Cotton”
and “Synthetics” programmes especially during
the rinse.
• Especially suitable for lightly soiled or small loads
(reduces the quantity of detergent).
• Not suitable for high temperature programmes.
“Rinse Hold” button
• The laundry remains in the last rinse water,
without progressing to the spin cycle to avoid
creasing and prevent colours from changing.
• This option is especially recommended for the
“Synthetics” or “Delicate” programmes.
• This option is perfectly suitable if you wish to
postpone the spin or you don't wish to spin the
clothes.
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton 90 5.0 72 1.80 115
Cotton 60 5.0 72 1.15 115
Coloured 60 2.0 66 0.80 100
Coloured 40 2.0 66 0.40 100
Quick Wash + 1/2 Load 40 2.5 54 0.50 85
Synthetics + 1/2 Load 30 1.0 54 0.30 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
PREPARATION OF WASH CYCLE PRESS ANY DESIRED OPTION BUTTON(S)
eco
Note:
the programme selector stops on “ ”.
Terminate the “Rinse Hold” option.
• Press the “Rinse Hold” button again; the
programme will terminate automatically with
the spin cycle corresponding to the previously
selected wash programme.
• If you do not wish to spin the clothes, switch off
the appliance by pressing the
“On/Off”
button.
The pilot light goes out. Turn the programme
selector to the “Drain” position and switch on
the appliance.
Open the water inlet tap and select the desired spin
speed, turning the spin speed and
“On/Off”
knob
to the desired position (the indicated spin speed or
“No Spin”). The pilot lamp lights up.
During the running programme, the door cannot be
opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical
power failure occurs, the door unlocks
automatically after about 1 minute.
• The programme selector knob is at “STOP”,
the pilot lamp lights.
1. Turn the spin speed knob to the Off position
“ ”. The pilot light goes out.
2. Cancel the options by pressing the appropriate
buttons.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload
the machine.
1. Turn the spin speed knob to the Off position
“ ” to switch off the appliance.
The pilot light goes out.
2. Select the new programme, temperature and
options.
3. Turn the spin speed knob to the desired spin
speed to switch on the appliance.
The pilot light lights.
1. Turn the spin speed knob to the Off position
“ ” to switch off the appliance.
The pilot light goes out.
2. Set the programme selector on “Drain”.
Turn the spin speed knob to the desired spin
speed to start the “Drain” programme.
Only open the door when the programme
selector is at “STOP” and the door is unlocked
(after approximately 1 minute).
• After switching your washing machine on, it
does not start immediately: it needs some
seconds in order to lock the door, fill water and
then drum starts turning.
• Spinning has an interrupted start-up: the drum
starts and stops running several times, to
improve spin efficiency and to better balance
the laundry.
• At the end of the spinning cycle the drum goes
on reversing for some minutes: this helps you
unloading the laundry.
• Do not exceed in detergents dosage: excessive
foam formation may prevent spinning.
• The turning of the drum is stopped in several
steps of the washing cycle due to optimization
of energy consumption.
PROGRAMME START
DOOR LOCK
PROGRAMME END
SELECTING A NEW PROGRAMME, SPIN
SPEED, OPTIONS AFTER PROGRAMME
START
TO STOP, RESET A PROGRAMME BEFORE
THE END
NOTES AND INDICATIONS FOR USE
2


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Ignis awv 516 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Ignis awv 516 in the language / languages: English as an attachment in your email.

The manual is 0,17 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Ignis awv 516

Ignis awv 516 User Manual - English - 15 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info