*)Recommended programme for use with “new generation” enzyme-based detergents.
**)For pre-rinse.
***)Values for normal conditions. Values may vary in relation to usage, e.g.: different loads, water temperatures, water hardness and power supply voltage.
1)Check the programme on the energy data plate.
Important:
•If a fault occurs or you wish to change the current programme, press
the “START” button for about 5 seconds until the Start indicator lamp
switches off! Refer to the “Troubleshooting guide” in these user
instructions to remedy any problems.
•Switch off the dishwasher once the “Start” indicator lamp has
switched off. If you switch off the dishwasher during a wash cycle,
when switched on again the dishwasher resumes the cycle from where
it was interrupted.
Start button indicator lamp:
Switches “on” when the dishwasher is operating.
Flashes when a fault occurs.
Switches off at the end of the programme.
Supply indicator lamp
Programme selector
Off.
Programme
Symbol
Load
Crockery and cutlery
Final rinse
temperature:
Detergent dispenser:
+) with pre-rinse
-) without pre-rinse
Consumption ***
Normal load
** small
compartment
large
compartment
Water
(Liter)
Energy
(kWh)
Time
(Min.)
Pre-rinse
Crockery to be washed later.---
8.00.0212
Bio-Eco 50 °C *
Normally soiled crockery, with dried-on food 65 °C++
Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.
Product:
Forumrules
To achieve meaningful questions, we apply the following rules:
First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.
Register
Register getting emails for Ignis ADL 334 at:
new questions and answers
new manuals
You will receive an email to register for one or both of the options.
Get your user manual by e-mail
Enter your email address to receive the manual of Ignis ADL 334 in the language / languages: English as an attachment in your email.
The manual is 0,15 mb in size.
You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.
If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.
The email address you have provided is not correct.
Please check the email address and correct it.
Your question is posted on this page
Would you like to receive an email when new answers and questions are posted? Please enter your email address.
