662878
3
Zoom out
Zoom in
Previous page
1/45
Next page
EN 54
Measures must be taken to prevent any accidental restarting of the device.
The safety of the device may be compromised, if, for example:
Malfunctions occur.
The housing of the device shows damage.
The device has been subjected to excessive loads.
The device has been stored improperly.
Markings or labels on the device are illegible.
It is recommended that a device which shows or which is suspected of faults and
damages is returned i.safe MOBILE GmbH for inspection.
EXRELEVANT SAFETY REGULATIONS
Use of this device assumes that the operator observes the conventional safety
regulations and has read and understood manual, safety instructions and certicate.
The following safety regulations must also be complied with:
Inside ex-hazardous areas the covers of the interfaces and the rear cover have
to be closed.
To ensure the IP protection, it has to be ensured that all gaskets are present and
functional. There must be no large gap between the two halves of the housing.
The battery may only be charged outside ex-hazardous areas.
The device may only be charged outside ex-hazardous areas using the appropriate
charger or other equipment approved by i.safe MOBILE GmbH.
The device may be charged only at temperatures in between 5°C … 35°C.
The device must not be exposed to abrasive acids or bases.
The device must not be taken into zones 0, 1, 20 or 21.
Only accessories approved by i.safe MOBILE GmbH may be used.
FURTHER SAFETY ADVISES
Do not touch the screen of the device with sharp objects. Dust particles and nails may
scratch the screen. Please maintain the screen clean. Remove dust on the screen with
a soft cloth gently, and do not scratch the screen.
Charge the device under indoor conditions only.
Do not put the device in environments with excessive temperatures, as this could lead
to heating of the battery, resulting in re or explosion.
Do not charge the device near any ammable or explosive substances.
Do not charge the device in environments with much dust, humidity, or excessively
high or low temperatures (the permitted charging temperature range is 5 … 35°C).
Do not use the device in areas where regulations or legislatives prohibit the use.
Do not expose the device or charger to strong magnetic elds, such as are emitted
from induction ovens or microwaves.
Do not attempt to open or repair the device. Improper repair or opening can lead to
the destruction of the device, re or explosion. Only authorized personnel are allowed
to repair the device.
ENGLISH
INTRODUCTION
This document contains information and safety regulations which are to be
observed in order to insure safe operation of the device IS740.2 under the described
conditions. Non-observance of this information and instructions can have serious
consequences and / or may violate regulations.
More detailed instructions on the use of the device can be found at
www.isafe-mobile.com or directly at i.safe MOBILE GmbH.
Please read the manual and these safety instructions before using the device.
In case of contradictory information, the text of these safety instructions shall apply.
In case of any doubt, the German version shall apply.
The current EU-declaration of conformity, certicates, safety instructions and manuals
can be found at www.isafe-mobile.com, or requested from i.safe MOBILE GmbH.
RESERVATION
Technical Data is subject to change without notice. Changes, errors and misprints may
not be used as a basis for any claim for damages. All rights reserved.
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and direct
or indirect damages caused by any improper use of this device.
EXSPECIFICATIONS
The IS740.2 is a device suitable for use in potentially explosive atmospheres classied
as zone 2/22 in accordance with directives 2014/34/EU and 2014/53/EU, as well as the
IECEx scheme.
EXMARKINGS
ATEX:
II 3G Ex ic IIC T4 Gc IP54
II 3D Ex ic IIIB T135 °C Dc IP54
EU Type Examination Certicate:
EPS 16 ATEX 1 068 X
CE-designation: 2004
IECEx:
Ex ic IIC T4 Gc IP54
Ex ic IIIB T135 °C Dc IP54
IECEx Certicate: IECEx EPS 16.0027 X
Temperature range:
-20 °C … +60 °C
Manufactured by:
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany
EUDECLARATION OF CONFORMITY
The EU-declaration of conformity can be found at the end of this manual.
FAULTS AND DAMAGES
If there is any reason to suspect that the safety of the device has been compromised, it
must be withdrawn from use and removed from any ex-hazardous areas immediately.
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for i.safe Mobile IS740.2 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of i.safe Mobile IS740.2 in the language / languages: English, German, Dutch, Danish, French, Italian, Polish, Portuguese, Swedish, Spanish, Norwegian, Finnish as an attachment in your email.

The manual is 1,16 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info