477557

Husqvarna CTH126 Manual

25
Zoom out
Zoom in
Previous page
1/88
Next page
25
2
TO ASSEMBLY BAGGER
• Remove clevis pin (6) and retainer spring (7) from bagger
handle (8).
• Slide bagger handle (8) down through bagger cover and
frame upper weldment holes.
• Reinstall clevis pin (6) through hole at bottom of bagger
handle and slide retainer spring (7) into hole at the end of
the clevis pin until it locks into place.
• Uninstall (1/4”-20) lock nuts (4) at bottom of front bagger frame.
• Unfold cross braces (5) and attach to carriage bolts at bottom
corners of front bagger frame.
• Reinstall (1/4”-20) lock nuts (4) and tighten until fully seated.
• Unfold bag and stand right side up.
• Feed front bagger frame (1) up through fabric loops at each
side of bagger.
• Snap bottom of front bagger frame (1) into snap feature at
front of bagger bottom.
• Slide bagger fabric loop (2) segments at the ends of bag
onto top bagger frame tubing.
• Uninstall two (1\4”-20 x 1.15”) hex bolts (3) from the front of
top frame.
• Reinstall the two (1\4”-20 x 1.15”) hex bolts (3) through holes
at top of the front bagger frame and thread into nuts inside
the tubing of top bagger frame.
TO ADJUST BAGGER FULL LEVER/PADDLE
• Before adjusting, tractor engine must be shut off and parking
brake engaged.
• For the heaviest/wet grasses, remove paddle (3).
• For lighter grasses use the paddle (3) on setting “1”, “2”, or
“3” (“3” being for the lightest or dry grass).
• Choose your setting and rotate the bagger paddle (3) so that
the desired number (setting) faces you.
• Setting may be changed by loosening fasteners (4 and 5),
removing/rotating paddle (3), and tightening again.
8
7
6
4
5
3
3
1
2
4
5
3
2
1
TO INSTALL BAGGER SPRING LATCH
The bagger spring latches are located on the back plate (1),
one in each of the bottom corners.
• Before installing, tractor engine must be shut off and parking
brake engaged.
• Install each bagger spring latch with the loop end (2) down
and facing towards the bagger assembly.
• Place the mounting bolt (3) through the curved end of the
bagger spring latch, through the back plate, and secure with
nut (4) as shown. Tighten firmly.
2
1
3
4
• The bottom of the bagger assembly should contact the loop
end so that it is held securely when closed.
… 25 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Husqvarna CTH126 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Husqvarna CTH126 in the language / languages: English, German, Dutch, French, Italian, Spanish as an attachment in your email.

The manual is 6,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info