661751
5
Zoom out
Zoom in
Previous page
1/8
Next page
To avoid the pump clogging - the
pump should not be placed on the
bottom of the water butt, this can be
achieved by either suspending the
pump from a rope attached to the
handle, or by placing the pump on 2
bricks (see Fig. 2).
The pump has a self priming vent to
remove any trapped air. The priming
process can take up to 5 minutes. For
faster priming lower the pump in to
the water without the hose
connected, and connect the hose
after a few seconds once the air has
escaped.
TO CONNECT TO AN IRRIGATION
SYSTEM:
For use with hoses and hose reels (see
Fig. 2) add a 2166 hose connector
(available separately) and pass hose
out through hole in lid of tank.
■
For use with micro irrigation system -
Do not use with a pressure regulator
(see Fig. 3) Remove inlet from
pressure regulator and attach directly
to the hose outside of the water butt
using a 2166 hose connector and a
2289 accessory adaptor (both
available separately).
TO DRAIN WATER:
- (see Fig. 4) add a 2166 hose
connector (available separately) and
place the end of hose in a suitably
sized and positioned container.
The Hozelock Water Butt Pump has a
built in thermal protection switch.
The pump stops if an overload
condition occurs. The motor restarts
automatically after it has cooled
down.
Insert the pump into a 220-240v A/C
socket.
In ordinary conditions the Water Butt
Pump does not require any
maintenance, however occasionally it
will be necessary to clean the two
filters and the inlet.
Make sure that the pump is
disconnected from the electric
power supply before performing
any maintenance.
To clean the coarse inlet filter,
remove filter cover on base of
pump by twisting clockwise (see
Fig 5A). Remove filter sponge and
rinse in clean water. Replace
sponge and re assemble filter
cover.
To clean the fine outlet filter,
remove tap connector on outlet of
pump, remove fine filter from
inside the tap connector and rinse
in clean water (see Fig 5B).
Replace fine filter in tap connector
and re-assemble. (NB This filter is
designed to protect your Hozelock
products from damage due to the
use of dirty water. It is essential to
use with micro irrigation,
AquaPod, & all Sprinklers. It is
optional with sprayguns , nozzles
& lances).
Store the pump in a dry place and
protect from frost.
Pump storage
Overload protection
Maintenance
To start the pump
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hozelock 2826 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hozelock 2826 in the language / languages: English as an attachment in your email.

The manual is 0,64 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info