Manual Hotpoint-Ariston AQD1071D 69 AQUALTIS (page 3 of 72) (English, German, Dutch, French, Portuguese, Spanish)

570651

3

Zoom out

Zoom in

Previous page

1/72

Next page

EN

3

Connecting the drain hose

Connect the drain

hose to drain duct

piping or a wall drain

located between 65

and 100 cm above

the floor, making sure

it is not bent at all.

Alternatively, rest the

drain hose on the

side of a washbasin

or bathtub, fastening

the duct supplied to

the tap (see figure).

The free end of the

hose should not be

underwater.

! We advise against the use of hose extensions;

if it is absolutely necessary, the extension must

have the same diameter as the original hose

and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the

electricity socket, make sure that:

• the socket is earthed and complies with all

applicable laws;

• the socket is able to withstand the maximum

power load of the appliance as indicated in

the Technical data table (see opposite);

• the power supply voltage falls within the

values indicated in the Technical data table

(see opposite);

• the socket is compatible with the plug of the

appliance. If this is not the case, have the

socket or the plug replaced.

! The machine must not be installed outdoors,

even in covered areas. It is extremely

dangerous to leave the appliance exposed to

rain, storms and other weather conditions.

! The mains socket must remain within easy

reach after the Washer-dryer has been installed.

! Do not use extension cords or multiple sockets.

! The cable should not be bent or compressed.

! The power supply cable and plug must only

be replaced by authorised technicians.

Warning! The company shall not be held

responsible in the event that these regulations

are not respected.

65 - 100 cm

Technical data

Model

AQD1071D 69

Dimensions

width 59.5 cm

height 85 cm

depth 64.5 cm

Capacity

from 1 to 10 kg for the wash

programme

from 1 to 7 kg for the drying

programme

Electrical

connections

please refer to the technical

data plate fixed to the ma-

chine

Water con-

nections

maximum pressure

1 MPa (10 bar)

minimum pressure

0.05 MPa (0.5 bar)

drum capacity 71 litres

Spin speed

up to 1600 rotations per

minute

Energy ra-

ted

programmes

according to

regulation

EN 50229

Wash: programme

; tem-

perature 60°C; using a load

of 10 kg.

Drying: the smaller load

(3kg) must be dried by se-

lecting the “Hanger” dryness

level. The load must consist

of 3 sheets, 2 pillowcases

and 2 hand towels;

the remainder of the load

must be dried by selecting

the “Extra” dryness level.

This appliance conforms to

the following EC Directives:

- 2004/108/EC (Electroma-

gnetic Compatibility)

- 2006/95/EC (Low Voltage)

- 2012/19/EU

1

We have two Hotpoint Ariston Aqualtis AQD1071D 69 washer/dryers. Both have the same issue, they automatically start a new program (within ~5 mins) after the original one ended. So, unless we're waiting near the washer -- to end it manually -- it restarts the program, and spoils water and heat.
Additionally, both of them give the error "No water check supply" while in the 'middle' of certain programs. There does not seem to be real problem with the water supply, water is used in other parts of the programs, and if we ignore the error,the program just continues after a few minutes (and will automatically start a new program when done :)) Submitted on 4-3-2017 at 14:38
Reply Report abuse
- Ow, sorry, my question is if anybody has any idea on what creates this problem, and how this might be fixed? Answered on 4-3-2017 at 14:51
  Vote up Report abuse

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

Register

Register getting emails for Hotpoint-Ariston AQD1071D 69 AQUALTIS at:

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hotpoint-Ariston AQD1071D 69 AQUALTIS in the language / languages: English, German, Dutch, French, Portuguese, Spanish as an attachment in your email.

The manual is 8,63 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info