624649
5
Zoom out
Zoom in
Previous page
1/48
Next page
Page 2
Safety Information
DANGER - RISK OF ELECTRICAL SHOCK
Install at least 5 feet (1.5 m) from all metal surfaces. A spa may
be installed within 5 feet of a metal surface if each metal surface is
permanently connected by a minimum No. 8 AWG (8.4 mm
²
) solid
copper conductor attached to the wire ground connector on the
terminal box that is provided for this purpose if in accordance with
National Electrical Code ANSI/NMFPA70-1993.
Do not permit any electrical appliances, such as a light, telephone,
radio, or television within 5 feet (1.5 m) of a spa. Failure to maintain
a safe distance may result in death, or serious personal injury due to
electrocution, if the appliance should fall into the spa.
Install your spa is such a way that drainage is away from the electrical
compartment and from all electrical components.
DO:
Be sure your spa is connected to the power supply correctly - use a
licensed electrical contractor.
Disconnect the spa from the power supply before draining the spa or
servicing the electrical components.
Test the Ground Fault Circuit Interrupter(s) before each use.
Replace audio components only with identical components (if your spa
is equipped with an audio component).
DON'T:
Use the spa with the equipment compartment door removed.
Place electrical appliances within 5 feet (1.5m) of the spa.
Use an extension cord to connect the spa to its power source. The
cord may not be properly grounded and the connection is a shock
hazard. An extension cord may cause a voltage drop, which will cause
overheating of the jet pump motor and motor damage.
Attempt to open the electrical control box. There are no user serviceable
parts inside.
RISKS TO AVOID
DANGER - RISK OF INJURY
To reduce the risk of injury to persons, DO NOT remove suction fittings
(filter standpipes) located in the filter compartment.
The suction fittings in the spa are sized to match the specific water
flow created by the pump. Never replace a suction fitting with one
rated less than the flow rate marked on the original suction fitting.
There is a danger of slipping and falling. Remember that wet surfaces
can be very slippery. Take care when entering or exiting the spa.
Never operate spa if the suction fittings are broken or missing.
People with infectious diseases should not use the spa.
Keep any loose articles of clothing, long hair, or hanging jewelry away
from rotating jets or other moving components.
INCREASED SIDE EFFECTS OF MEDICATION
The use of drugs, alcohol may cause unconsciousness with the
possibility of drowning.
Persons using medications should consult a physician before using
a spa; some medication may cause a user to become drowsy, while
other medication may affect heart rate, blood pressure, and circulation.
Persons taking medications which induce drowsiness, such as
tranquilizers, antihistamines, or anticoagulants should not use the spa.
HEALTH PROBLEMS AFFECTED BY SPA USE
Pregnant women should consult a physician before using spa.
Persons suffering from obesity, or with a medical history of heart
disease, low or high blood pressure, circulatory system problems, or
diabetes should consult a physician before using spa.
UNCLEAN WATER
Keep the water clean and sanitized with correct chemical care. The
recommended levels for your HOT SPRING spa are:
Free Available Chlorine:
3.0-5.0 ppm
Total Alkalinity:
40-120 ppm
Water pH:
7.2-7.6
Calcium Hardness:
50-150 ppm
Refer to Water Quality and Maintenance section for complete
instructions.
IMPORTANT: Turn on the jet pump for a least ten minutes after adding
ANY spa water chemicals into the filter compartment.
Clean the filter cartridges monthly to remove debris and mineral buildup
which may affect the performance of the hydromassage jets, limit the
flow, or trip the high limit thermostat, which will turn off the entire spa.
AVOIDING THE RISK OF HYPERTHERMIA
Prolonged immersion in hot water can result in HYPERTHERMIA, a
dangerous condition which occurs when the internal temperature of
the body reaches a level above normal 98.6°F (37°C). The symptoms
of hyperthermia include unawareness of impending hazard, failure to
perceive heat, failure to recognize the need to exit the spa, physical
inability to exit the spa, fetal damage in pregnant women, and
unconsciousness resulting in a danger of drowning.
WARNING
The use of alcohol, drugs, or medication can greatly increase the risk of
fatal hyperthermia in hot tubs and spas.
TO REDUCE THE RISK OF INJURY
The water in the spa should never exceed 104°F (40°C). Water
temperatures between 100°F and 104°F (36°C and 40°C) are
considered safe for a healthy adult. Lower water temperatures are
recommended for extended use (exceeding ten minutes) and for
young children. Extended use can cause hyperthermia.
Pregnant or possibly pregnant women should limit spa water
temperatures to 100°F (36°C). Failure to do so may result in
permanent injury to your baby.
Do not use spa immediately following strenuous exercise.
5


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Hot Spring ENVOY -KK at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Hot Spring ENVOY -KK in the language / languages: English as an attachment in your email.

The manual is 6,11 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info