641003
11
Zoom out
Zoom in
Previous page
1/13
Next page
MAINTENANCE
The safety level given by the design of Horizon Indoor Cycle can only maintain when the equipment is
regularly examined for damage and wear. Inoperable components should be replaced or the equipment
should be put out of use until it is repaired.
DAILY
Wipe down the Indoor Cycle after each use to remove sweat and moisture. Use soap and water, or
a diluted non-abrasive domestic cleaner solution. Rinse to remove detergent residue and then dry off.
Before each session, inspect for loose components such as pedals or cranks prior to com-mencing
the next class. Tighten up any loose parts.
WEEKLY
Check for proper flywheel alignment. Torque flywheel nuts as necessary.
Remove chain guard and check for loose chain. Adjust and lubricate the chain as neces-sary.
Check to make sure the crank arms are tight to the bottom bracket.
Inspect all parts, nuts, bolts, or screws for adjustments, replacements or maintenance
MONTHLY
Inspect the frame and main assembly components for rust or corrosion. Tilt the cycle or place in an
upside down position to locate areas where rust and corrosion may develop. Use a small, wire brush
to remove rust build-up in small crevasses, such as leveling feet, quick release levers and other bolt
assemblies.
Inspect all wear items for adjustments or possible part replacement. Give particular attention to the
following:
a). Inspect brake pad for wear. Excessive wear or dryness indicates replacement is required.
b). Inspect seat pad for wear. Rips, tears or excessive movement indicates replacement is required.
c). Inspect pedals for play. Excessive movement of pedals indicates replacement is required.
Inspect the chain for tensioning by rotating the crank to drive the flywheel forward. Do this motion in
1/4 turns to assess if there is free play between the crank and the flywheel.
Dryness or prolonged use may cause the height and reach adjustments for the seat and handlebar
to become tight. If this is the case, the sliding assembly should be removed from the frame and have
a smear of light duty grease applied along the sliding surface before assembly. Similarly, apply some
light grease to the clamping assembly to ensure it does not seize up. Clean off excessive grease
before reassembly.
20 21
11


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Horizon Fitness S3 - Indoor Cycle at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Horizon Fitness S3 - Indoor Cycle in the language / languages: English as an attachment in your email.

The manual is 3,82 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Horizon Fitness S3 - Indoor Cycle

Horizon Fitness S3 - Indoor Cycle Usermanual and installation guide - German - 24 pages

Horizon Fitness S3 - Indoor Cycle Usermanual and installation guide - Dutch - 26 pages

Horizon Fitness S3 - Indoor Cycle Usermanual and installation guide - French - 24 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info