Manual Hoover HOC024-6X (page 4 of 32) (English, Italian, Turkish)

594716

Zoom out

Zoom in

1/32

1. GENERAL WARNINGS

Thank you for choosing one of our products. To get the most out of your oven we recommend that you:

• Read the notes in this manual carefully: they contain important instructions on how to install, use and service this oven safely.

• Keep this booklet in a safe place for easy, future reference.

All accessible parts are hot when the appliance is in operation, take care to not touch these elements.

When the oven is first switched on it may give out acrid smelling fumes. This is because the bonding agent for insulating panels around

the oven has been heated up for the first time.

This is a completely normal, if it does occur you merely have to wait for the fumes to clear before putting the food into the oven.

An oven by its very nature becomes very hot. Especially the glass of the oven door.

The parts of this appliance that may come into contact with foodstuffs

comply with the provisions of EEC Directive 89/109. Appliance

complies with European Directives 73/23/EEC and

89/336/EEC, replaced by 2006/95/EC and 2004/108/EC, and

subsequent amendments. When you have unpacked the oven,

make sure that it has not been damaged in any way. If you have any

doubts at all, do not use it: contact a professionally qualified person.

Keep packing materials such as plastic bags, polystyrene, or nails out

of the reach of children because they are dangerous for children.

04 GB

1.1 DECLARATION OF COMPLIANCE

1.2 SAFETY HINTS

•The oven must be used only for the purpose for which it was

designed: it must only be used for cooking food. Any other use, e.g. as

a form of heating, is an improper use of the oven and is therefore

dangerous.

•The manufacturers cannot be held responsible for any damage

caused by improper, incorrect or unreasonable use. When using any

electrical appliance you must follow a few basic rules.

– Do not pull on the power cable to remove the plug from the socket.

– Do not touch the oven with wet or damp hands or feet.

– Do not use the oven unless you are wearing something on your feet.

– It is not generally a good idea to use adapters, multiple sockets for

several plugs and cable extensions.

– If the oven breaks down or develops a fault switch it off at the mains

and do not touch it.

•If the cable is at all damaged it must be replaced promptly.

When replacing the cable, follow these instructions. Remove the

power cable and replace it with one of the H05RRF, H05VV-F,

H05V2V2-F type. The cable must be able to bear the electrical current

required by the oven. Cable replacement must be carried out by

properly qualified technicians. The earthing cable (yellow-green) must

be 10 mm longer than the power cable.

Use only an approved service centre for repairs and ensure that only

original parts are used. If the above instructions are not adhered to the

manufacturers cannot guarantee the safety of the oven.

•Do not line the oven walls with aluminium foil or single-use

protection available from stores. Aluminium foil or any other

protection, in direct contact with the hot enamel, risks melting

and deteriorating the enamel of the insides.

1.3 INSTALLATION

Installation is the customer’s responsibility. The manufacturers have

no obligation to carry this out. If the assistance of the manufacturer is

required to rectify faults arising from incorrect installation, this

assistance is not covered by the guarantee.

The installation instructions for professionally qualified personal must

be followed. Incorrect installation may cause harm or injury to people,

animals or belongings. The manufacturer cannot be held responsible

for such harm or injury.

Plug into the power supply. Ensure first that there is a third contact that

acts as earthing for the oven. The oven must be properly earthed.

If the model of oven is not fitted with a plug, fit a standard plug to the

power cable. It must be able to bear the power supply indicated on the

specifications plate. The earthing cable is yellowgreen. The plug must

be fitted by a properly qualified person. If the socket and the plug are

incompatible the socket must be changed by a properly qualified

person.A properly qualified person must also ensure that the power

cables can carry the current required to operate the oven.

An ON/OFF switch may also be connected to the power supply. The

connections must take account of the current supplied and must

comply with current legal requirements. The yellow-green earthing

cable must not be governed by the ON/OFF switch. The socket or the

ON/OFF switch used for connecting to the power supply must be

easily accessible when the oven has been installed.

Important: During installation, position the power cable in such a way

that it will not be subjected to temperatures of above 50°C at any point.

The oven complies with safety standards set by the regulatory bodies.

The oven is safe to use only if it has been adequately earthed in

compliance with current legal requirements on wiring safety. You must

ensure that the oven has been adequately earthed.

The manufacturers cannot be held responsible for any harm or

injury to persons, animals or belongings caused by failure to

properly earth the oven.

WARNING: the voltage and the supply frequency are showed on

the rating plate (fig. on last page).

The cabling and wiring system must be able to bear the maximum

electric power required by the oven. This is indicated on the

specifications plate. If you are in any doubt at all, use the services of a

professionally qualified person.

1.6 CONNECTING TO THE POWER SUPPLY

If the oven is to work properly, the kitchen housing must be suitable.

The panels of the kitchen unit that are next to the oven must be made

of a heat resistant material. Ensure that the glues of units made of

veneered wood can withstand temperatures of at least 120 °C.

Plastics or glues that cannot withstand such temperatures will melt

and deform the unit. Once the oven has been lodged inside the unit,

the electrical parts must be completely insulated. This is a legal safety

requirement. All guards must be firmly fixed into place so that it is

impossible to remove them without using special tools.

Remove the back of the kitchen unit to ensure an adequate

current of air circulates around the oven. The hob must have a

rear gap of at least 45 mm.

1.5 IMPORTANT

1.4 FITTING THE OVEN INTO THE KITCHEN

UNIT

Fit the oven into the space provided in the kitchen unit; it may be fitted

underneath a work top or into an upright cupboard.

Fix the oven in position by screwing into place, using the two fixing

holes in the frame.(Fig.on last page).

To locate the fixing holes, open the oven door and look inside.To allow

adequate ventilation, the measurements and distances indicated in

the diagram on last page must be adhered to when fixing the oven.

Note: For ovens that are combined with a hob unit the instructions

contained in the manual for the hob unit must be followed.

It is necessary to do an initial cleaning

of the equipment before the first use of

each of them.Wash them with a sponge.

Rinse and dry off.

The simple shelf can take moulds and

dishes.

The tray holder shelf is especially good

for grilling things. Use it with the drip tray.

The special profile of the shelves means

they stay horizontal even when pulled right

out. There is no risk of a dish sliding or

spilling.

1.7 OVEN EQUIPMENT (according to the model)

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Hoover HOC024-6X in the language / languages: English, Italian, Turkish as an attachment in your email.

The manual is 1,35 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Hoover HOC024-6X Manual

Product: