Manual Honeywell HZ-519 Series (page 1 of 5) (English)

527132

Zoom out

Zoom in

1/5

IMPORTANT

SAFEGUARDS

READ AND SAVE THESE

SAFETY INSTRUCTIONS

BEFORE USING THIS HEATER.

When using electrical appliances, basic precautions

should always be followed to reduce the risk of fire,

electric shock, and injury to persons, including the

following:

IMPORTANT

INSTRUCTIONS

1. Read all instructions before using this heater.

2. This heater is hot when in use. To avoid burns, do not

let bare skin touch hot surface. If provided, use han-

dles when moving this heater. Keep combustible

materials, such as furniture, pillows, bedding,

papers, clothes, and curtains at least 3 feet (0.9 m)

from the front of the heater and keep them away from

the sides and rear.

3. Extreme caution is necessary when any heater is

used by or near children or invalids and whenever

the heater is left operating and unattended.

4. Always unplug heater when not in use.

5. Do not operate any heater with a damaged cord or

plug or after the heater malfunctions, has been

dropped or damaged in any manner. Return heater

to authorized service facility for examination, electri-

cal or mechanical adjustment, or repair.

6. Do not use outdoors.

7. This heater is not intended for use in bathroom, laun-

dry areas and similar moist indoor locations. Never

locate heater where it may fall into a bathtub or other

water container.

8. Do not run cord under carpeting. Do not cover cord

with throw rugs, runners, or the like. Arrange cord

away from traffic area where it will not be tripped

over.

9. This heater is for use on 120 volts. The cord has a

grounded plug as shown in

Fig. 1. An adapter is

available at retail (not included) for connecting three-

blade grounding-type plugs to two-slot receptacles.

The green grounding lug extending from the adapter

must be connected to a permanent ground such as a

properly grounded outlet box. The adapter should not

be used if a three-slot grounded receptacle is avail-

able.

10. This heater draws 12.5 amps during operation. To

prevent overloading a circuit, do not plug the heater

into a circuit that already has other appliances work-

ing.

11. It is normal for the plug to feel warm to the touch;

however, a loose fit between the AC outlet (recepta-

cle) and plug may cause overheating and distortion

of the plug. Contact a qualified electrician to replace

loose or worn outlet.

12. To disconnect the heater, first turn controls to the

OFF position, then grip the plug and pull it from the

wall outlet. Never pull by the cord.

13. Do not insert or allow foreign objects to enter any

ventilation or exhaust opening as this may cause an

electric shock or fire, or damage the heater.

14. To prevent a possible fire, do not block air intakes or

exhaust in any manner. Do not use on soft surface,

like a bed, where openings may become blocked.

15. A heater has hot and arcing or sparking parts inside.

Do not use it in the areas where gasoline, paint, or

flammable liquids are used or stored.

16. Use this heater only as described in this manual.

Any other use not recommended by the manufac-

turer may cause fire, electric shock, or injury to per-

sons.

17. Avoid the use of an extension cord because the

extension cord may overheat and cause a risk of fire.

However, if you have to use an extension cord, the

cord shall be No. 14 AWG minimum size and rated

not less than 1875 watts.

18. The output of this heater may vary and its tempera-

ture may become intense enough to burn exposed

skin. Use of this heater is not recommended for per-

sons with reduced sensitivity to heat or an inability to

react to avoid burns.

19. SAVE THESE

INSTRUCTIONS.

DIGITAL LOW

PROFILE HEATER

HZ-519 Series

Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

Forumrules

To achieve meaningful questions, we apply the following rules:

First, read the manual;
Check if your question has been asked previously;
Try to ask your question as clearly as possible;
Did you already try to solve the problem? Please mention this;
Is your problem solved by a visitor then let him/her know in this forum;
To give a response to a question or answer, do not use this form but click on the button 'reply to this question';
Your question will be posted here and emailed to our subscribers. Therefore, avoid filling in personal details.

new questions and answers
new manuals

You will receive an email to register for one or both of the options.

Get your user manual by e-mail

Enter your email address to receive the manual of Honeywell HZ-519 Series in the language / languages: English as an attachment in your email.

The manual is 0,58 mb in size.

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.

Info

Honeywell HZ-519 Series Manual

Product: