630635
1
Zoom out
Zoom in
Previous page
1/2
Next page
HOW TO GET STARTED
987000390
3-9-12 (REV: 03)
CALL
1-800-242-4672
www.homelite.com
Make The Most Of Your Purchase!
For any questions about operating or maintaining your product, call the Homelite Help Line !
Your Product has been fully tested prior to shipment to ensure your complete satisfaction.
Troubleshooting tips are available in your operator's manual.
Go to www.homelite.com and register your new tool on-line.
IMPORTANT: It is normal for chain saws to have bar and chain lubricant under the chassis after operating
the saw. This bar and chain lubricant is coming from the clutch cover area and is NOT an indication of a
leak. The clutch cover area must be saturated with lubricant to properly lubricate the bar and chain and
to ensure the long-term durability of your new chain saw.
®
1
Press fully and release
PRIMER BULB 7 times.
9
10
Add bar lubricant to oil tank.
Set ignition switch to
RUN (I) position.
Pull CHOKE lever to the
FULL position.
Allow engine to warm for
30 seconds. DEPRESS throttle release
then SQUEEZE and release throttle trigger.
Pull STARTER grip until
engine runs.
1 GALLON
GAS
1
2
3
4
5
6
Above 50
º
F - Pull STARTER 3 times
Below 50
º
F - Pull STARTER 5 times
7
BAR
OIL
8
Push choke lever to
RUN position.
x7
Note: Allow the saw to run in this position
15-30 seconds, depending upon the temperature.
50:1 Ratio = Mix 2.6 oz of 2-cycle engine lubricant (provided)
with 1 gallon of fresh gasoline in separate gas container.
SHAKE. Pour into fuel tank.
O
WARNING: This Engine Starting Procedure is not a substitute for
reading the operator’s manual. To reduce the risk of injury, user must
read and understand operator’s manual before using this product.
1


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Homelite UT10566 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Homelite UT10566 in the language / languages: English, French as an attachment in your email.

The manual is 2,59 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Homelite UT10566

Homelite UT10566 User Manual - English, French, Spanish - 120 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info