518481

Homedics WTR-BOT Manual

3
Zoom out
Zoom in
Previous page
1/27
Next page
54
GB
GB
Installing/Changing the Batteries
1. Unscrew the battery cap from the massage mechanism using the centre 2 lugs marked
‘Lock – Unlock’ (Fig 5 & 6).
2. Place 2 x AA batteries into the chamber (negative [-] first) as indicated on the compartment
(observe +/- polarity as indicated on the outside of the massage unit and yellow label inside
the compartment (Fig 7, 8 & 9).
3. Replace the battery cap on the massage mechanism using the centre 2 lugs marked
‘Lock – Unlock’ (Fig 10 & 11).
Fig 5 Fig 6 Fig 7
Fig 8 Fig 9 Fig 10
Fig 11
Battery Precautions
• Use only the size and type of batteries specified (2 “AA”).
• When installing batteries, observe proper +/– polarities. Incorrect installation of battery may
cause damage to the unit.
• Do not mix different types of batteries together (e.g., alkaline with carbon-zinc or old batteries
with new ones).
• If the unit is not going to be used for a long period of time, remove batteries to prevent
damage due to possible battery leakage.
• Do not dispose of batteries in fire. Batteries may explode or leak.
• Do not immerse battery compartment in water.
Filling the Water Bottle
1. Unscrew and remove the massage mechanism as described in ‘removing the massage
mechanism’ section.
2. Slide the massage mechanism out of the water bottle (Fig 12).
3. Holding the water bottle open in an upright position (Fig 13).
4. When filling the hot water bottle, do not use boiling water and fill to a maximum of two-thirds
capacity (1.25 ltrs, 42 fl. oz.) with hot water from a kettle which has been left to stand for one
minute. Hold the bottle by the neck in an upright position and fill slowly to avoid hot water
splashing back (Fig 14 & 15)
5. Insert the massage mechanism stopper to within 2cm of closing (Fig 16). Then expel the
excess air by lowering it carefully onto a flat surface until water is just visible through the
opening.
6. Screw the massage mechanism sufficiently tight to ensure that there is no leakage. Finger
tight should be adequate (Fig 17).
Fig 12 Fig 13 Fig 14
Fig 15 Fig 16 Fig 17
NOTE:
• Do not fill using water from the domestic hot water system as this can considerably shorten
the life of the hot water bottle.
• Prevent contact with hot surfaces.
• Prevent contact with oil or grease.
• When not in use, drain completely and keep, with the stopper removed, in a cool, dry, dark
place. Prevent exposure to sunlight. Do not place anything on top of the bottle.
• Check the bottle and stopper for wear and damage at regular intervals.
• Replace water bottle cap and make sure it is on securely
• Test for leakage by turning bottle upside down and pressing firmly.
• Water Bottle may be used without massage function.
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Homedics WTR-BOT at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Homedics WTR-BOT in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 0,39 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info