518466

Homedics SS-4500-3 Manual

3
Zoom out
Zoom in
Previous page
1/35
Next page
5
GB
Setting the clock
1. Press and hold the HOUR button for 5 seconds (Fig. 5). The time will begin to flash
2. While the time is flashing, press the HOUR button until you reach the correct hour.
Then press the MINUTE button (Fig. 5) until you reach the correct minute.
Note: PM indicator will appear on the left side of the clock face for evening
hours (Fig. 5). If the PM indicator is not illuminated, the hour is set to AM. Be
sure to set the time for the correct 12-hour period – AM (morning) or PM
(evening). After 5 seconds, the time will stop flashing and it will be set.
3. Press the BACKLIGHT HIGH/LOW button (Fig. 4) to choose between high and low
clock brightness.
Listening to Nature Sounds
1. Select the sound you wish to listen to and press the corresponding button (Fig 2).
2. To adjust the volume, turn the VOLUME knob (Fig 1) to your desired level.
3. When finished listening to the sounds you may turn them off by pressing the POWER
button, or switch to the radio by pressing RADIO (Fig 5).
Note: When the unit is turned on it will always default to the last mode used.
4
GB
SAFETY CAUTIONS :
• Never cover the appliance when it is in operation.
• This unit should not be used by children without adult supervision.
• Always keep the cord away from high temperature and fire.
• Do not lift, carry, hang, or pull the product by the power cord.
• If the adaptor sustains damage, you must stop using this product immediately and
contact the HoMedics Service Centre.
INSTRUCTIONS FOR USE :
1. Unpack the product and check to make sure everything is included (Fig 1).
2. This unit is powered by a DC adaptor, which is included.
3. The battery power is designed only to provide MEMORY BACK-UP for the clock and
alarm settings. One 9V battery (not included) should be inserted into the battery
compartment if memory back-up is desired (in the event of power outages or if the
unit is unplugged). However, the time will not be illuminated on the clock display.
As soon as the power supply returns, the display will indicate the correct time.
Note: Battery must be installed in order for clock memory back-up to operate.
In the event of a power failure or disconnection, if the battery is not installed,
the clock and alarm will need to be re-set when power is restored.
4. To install battery, remove compartment cover. Insert one 9V battery into the
compartment on the bottom of the unit following the diagram. Replace cover and
snap into place.
5. Attach the DC adaptor to the jack located on the back of the unit (Fig 4) and insert
the cord into a 230V power supply.
Tuner
Sounds
Focus Knob
Figure 1
Clock Radio/
Control Panel
Volume
Sounds
Time Rotation Knob
3 …


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Homedics SS-4500-3 at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Homedics SS-4500-3 in the language / languages: English, German, Dutch, French, Italian, Polish, Spanish as an attachment in your email.

The manual is 0,48 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info