665929
3
Zoom out
Zoom in
Previous page
1/10
Next page
SLOGBD
HR
Die passenden Dübel und Schrauben
sind im Lieferumfang enthalten.
Alternativ kann der Sender auch mit
einem Klebesockel befestigt werden,
der ebenfalls im Lieferumfang enthalten
ist. (Nur für geeignete Oberflächen)
Wichtig
Durch Montieren des Senders auf
weichmacherfreie PVC Türrahmen oder
Metalloberflächen wird die Reichweite
eingeschränkt!
Unter einer durchsichtigen
Schutzkappe, auf der Vorderseite des
Senders befindet sich ein beschriftbares
Namensschild.
Melodienauswahl
Der Melodienregler befindet sich im
Sender auf der rechten Seite über der
Batterie und ist mit einem “S” markiert.
Durch einfaches drücken auf den Regler
ändert sich die Melodie gemäß der
unten aufgeführten Liste.
Einstellmöglichkeiten:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
Durch Betätigen des Senders wird ein
Signal an den Empfänger gesendet. Um
den Rufton zu wiederholen, drücken Sie
den Klingeltaster erneut. Der Rufton
wird nur 1x erfolgen, auch wenn Sie
den Klingeltaster gedrückt halten.
Alternativno se lahko oddajnik pritrdi s
pomočjo lepilnega podnožja, ki je prav
tako vsebovano v obsegu dobave.
(Samo za ustrezne površine)
Pomembno
Z montažo oddajnika na vratne okvirje,
izdelane iz PVC-ja brez mehčal, ali na
kovinske površine, se domet omeji!
Pod prozornim zaščitnim pokrovom na
sprednji strani oddajnika se nahaja
ploščica, na katero se lahko napiše ime.
Izbiranje melodij
Regulator melodij se nahaja v oddajniku
na desni strani nad baterijo in je
označen s črko "S". S pritiskom na
regulator se melodija spremeni v skladu
s spodaj navedenim seznamom.
Možnosti nastavitve:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
S pritiskom na oddajnik se pošlje signal
sprejemniku. Da zvonjenje ponovite,
ponovno pritisnite na gumb za zvonec.
Zvonjenje se zasliši samo 1x, tudi če
gumb za zvonec držite pritisnjen.
Alternativno odašiljač možete također
pričvrstiti pomoću ljepljivog postolja koje
je također priloženo.
(Samo za odgovarajuće površine)
Važno
Montiranjem odašiljača na PVC okvire
vrata bez omekšivača ili metalne
površine ograničuje se domet!
Pod prozirnom zaštitnom kapom na
prednjoj strani odašiljača nalazi se
natpisna pločica.
Odabir melodije
Regulator melodija nalazi se u
odašiljaču na desnoj strani iznad baterije
i označen je slovom „S“. Pritiskom na
regulator
melodija se mijenja u skladu s dolje
navedenom listom.
Mogućnosti namještanja:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
Aktiviranjem odašiljača prijemniku se
šalje signal. Kako biste ponovili pozivni
ton, iznova pritisnite tipku zvona.
Pozivni ton ponovit će se samo 1x
čak i ako tipku zvona držite pritisnutu.
Instalacija baterije oddajnika
Oddajnik poganja 3 voltna litijeva
baterija CR2032, ki je vsebovana
v obsegu dobave in že vložena.
Odstranite samo zaščitno folijo, ki
ob strani gleda ven iz oddajnika,
tako da se vzpostavi električni
kontakt.
Za menjavanje baterije najprej
odstranite hrbtno stran oddajnika,
tako da zapah s pomočjo ozkega
izvijača previdno vtisnete.
Staro baterijo zamenjajte.
Prekontrolirajte, ali je baterija v
skladu z navedeno polarizacijo
(+ = zgoraj) pravilno vstavljena.
Hrbtno in sprednjo stran
oddajnika zopet sestavite.
Oddajnik je sedaj j pripravljen
za uporabo.
Priključitev sprejemnika na vtičnico
Brezžični sprejemnik se za
napajanje priključi na vtičnico in
ne potrebuje baterij. S pomočjo
spojnika z vtičnico na sprednji
strani brezžičnega sprejemnika
lahko vtičnico, na katero je
naprava priključena, še naprej
uporabljate.
Pritrditev oddajnika
Obe predhodno narejeni luknji
na hrbtni strani oddajnika lahko
uporabite kot šablono za
označevanje vrtin. Ustrezni zatiči
in vijaki so vsebovani v obsegu
dobave.
Alternatively the trans-mitter can be
fixed with an adhesive base, which is
also included in delivery.
(Only for use on suitable surfaces)
Important
When mounting the transmitter on rigid
PVC door frames or metal surfaces the
range will be limited!
Below the see-through protective
cap on front of transmitter is
a name plate, which can be
labelled.
Selection of Melody
The melody control within the
transmitter is situated on the right
above the battery and is marked
“S”. By pressing the control the
melody changes as listed below.
Adjustment Options
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
By pressing the transmitter a signal is
sent to the receiver. To repeat the call
signal press the bell push-button
again. The call signal sounds only once,
even if bell push-button is pressed
constantly.
Transmitter Battery Installation
The transmitter is operated by
a 3 Volt Lithium CR2032 battery,
which is included in delivery
and is pre-installed inside the
transmitter.
Just remove the protective foil
sticking out from the side of
transmitter, which will establish
the electrical contact.
To replace the battery first
remove the back cover of
transmitter by carefully pressing
the latch with a small, narrow
screwdriver.
Replace the old battery.
Please check if the battery is
inserted correctly according to the
polarity (+ = up).
Reassemble the back and front
of the transmitter. The transmitter
is now ready for operation.
Receiver Wall Socket Connection
The wireless receiver can be
connected to a wall socket for
electricity supply and does not
need any batteries. By the use of
the wall socket connector on
front of the wireless receiver, the
wall socket which is used for the
device, can still be used for other
purposes.
Mounting the Transmitter
The pre-cut holes on the back of
transmitter can be used as a
template to mark the drilling
holes. The respective wall-plugs
and screws are included in
delivery.
3
2
3


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70822 - HX Curve at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70822 - HX Curve in the language / languages: English as an attachment in your email.

The manual is 0,22 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70822 - HX Curve

Heidemann 70822 - HX Curve User Manual - German, Dutch, French, Italian - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info