665927
4
Zoom out
Zoom in
Previous page
1/10
Next page
Sender Befestigung
Sie können die beiden vorgestanzten
Löcher auf der Rückseite des Senders
als Schablone verwenden, um die
Bohrlöcher zu markieren. Die
passenden Dübel und Schrauben sind
im Lieferumfang enthalten. Alternativ
kann der Sender auch mit einem
Klebesockel befestigt werden, der
ebenfalls im Lieferumfang enthalten ist.
(Nur für geeignete Oberflächen)
Wichtig:
Durch Montieren des Senders auf
weichmacherfreie PVC Türrahmen oder
Metalloberflächen, wird die Reichweite
eingeschränkt!
Unter einer durchsichtigen
Schutzkappe, auf der Vorderseite
des Senders befindet sich ein
beschriftbares Namensschild.
Empfänger Befestigung
Der Empfänger hat auf der Rückseite
einen Befestigungs-Clip mit integriertem
Befestigungsloch. Dadurch kann das
Gerät an einer Schraube aufgehangen
oder jederzeit beliebig in einen anderen
Raum mitgenommen werden. Das
Befestigungsmaterial (Dübel und
Schraube) ist im Lieferumfang
enthalten. Achten Sie bei der Montage
darauf, dass zwischen Wand und
Empfänger ein Abstand von ca. 3 mm
gelassen wird, damit das Gerät locker
eingehangen werden kann.
Melodienauswahl
Der Melodienregler befindet sich
im Sender auf der rechten Seite
über der Batterie und ist mit einem
“S” markiert.
Durch drücken auf den Regler
ändert sich die Melodie gemäß der
unten aufgeführten Liste.
Einstellmöglichkeiten:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
Durch Betätigen des Senders wird ein
Signal an den Empfänger gesendet.
Um den Rufton zu wiederholen,
drücken Sie den Klingeltaster erneut.
Der Rufton wird nur 1x erfolgen, auch
wenn Sie den Klingeltaster gedrückt
halten.
Anwendung des ON/OFF Schalters
und des Vibrationsalarms
An der Seite des Empfängers
befindet sich ein ON/OFF-
Schalter. Wenn Sie den Schalter auf
OFF stellen, wird der Gong auch
dann nicht ertönen, wenn Batterien
eingelegt sind und der Sender
betätigt wurde.
Der rechte Schalter (Mode) auf
der Rückseite des Empfängers
dient zum Ein- bzw. Ausschalten
des Vibrationsalarms, der beim
Betätigen des Senders aktiviert
wird.
By pressing the control the
melody changes as listed below.
Adjustment Options
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
By pressing the transmitter a signal
is sent to the receiver. To repeat the
call signal press the bell
push-button again. The call signal
sounds only once, even if bell
push-button is pressed constantly.
Use of ON/OFF-Switch and
Vibration Alarm
On the side of the receiver is a
switch labelled “ON/OFF”
If the switch is set to OFF, the
chime will not sound, even if
batteries were placed inside and
the transmitter was pressed.
The right switch (Mode) on the back
of the receiver serves as an on/off
switch for the vibration alarm, which
is activated when the transmitter is
operated.
S pritiskom na regulator se melodija
spremeni v skladu s spodaj
navedenim seznamom.
Možnosti nastavitve:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
S pritiskom na oddajnik se pošlje
signal sprejemniku. Da zvonjenje
ponovite, ponovno pritisnite na
gumb za zvonec. Zvonjenje se
zasliši samo 1x, tudi če gumb za
zvonec držite pritisnjeno.
Uporaba stikala ON/OFF
in vibracijskega alarma
Ob strani sprejemnika je stikalo,
ki je označeno z oznako ON/OFF.
Če stikalo preklopite na OFF, se
zvonec ne bo oglasil niti, če so
baterije vstavljene in je oddajnik
aktiviran.
Desno stikalo (Mode) na hrbtni
strani sprejemnika je namenjeno
za vklop oz. izklop vibracijskega
alarma, ki se aktivira pri sproženju
oddajnika.
SLOGBD
HR
Pritiskom na regulator
melodija se mijenja u skladu s dolje
navedenom listom.
Mogućnosti namještanja:
1. Westminster
2. Ding-Dong
3. Tubular bells 1
4. Tubular bells 2
5. Popsound 1
6. Piano
7. Popsound 2
8. Old Bell
Aktiviranjem odašiljača prijemniku
se šalje signal. Kako biste ponovili
pozivni ton, iznova pritisnite tipku
zvona. Pozivni ton ponovit će se
samo 1x čak i ako tipku zvona
držite pritisnutu.
Primjene sklopke ON/OFF
i vibracijskog alarma
Na bočnoj stranici prijamnika nalazi
se sklopka označena natpisom
ON/OFF. Ako sklopku postavite na
OFF, signalno zvono neće se čuti
čak niti kada su baterije umetnute i
odašiljač aktiviran.
Desna sklopka (Mode) na poleđini
prijamnika nalazi služi za
ukljucivanje odn. iskljucivanje
vibracijskog alarma koji se aktivira
prilikom aktiviranja odašiljaca.
Mode
Code
Setting
Switch
4
3
4


Need help? Post your question in this forum.

Forumrules


Report abuse

Libble takes abuse of its services very seriously. We're committed to dealing with such abuse according to the laws in your country of residence. When you submit a report, we'll investigate it and take the appropriate action. We'll get back to you only if we require additional details or have more information to share.

Product:

For example, Anti-Semitic content, racist content, or material that could result in a violent physical act.

For example, a credit card number, a personal identification number, or an unlisted home address. Note that email addresses and full names are not considered private information.

Forumrules

To achieve meaningful questions, we apply the following rules:

Register

Register getting emails for Heidemann 70820 - HX ICE at:


You will receive an email to register for one or both of the options.


Get your user manual by e-mail

Enter your email address to receive the manual of Heidemann 70820 - HX ICE in the language / languages: English as an attachment in your email.

The manual is 0,24 mb in size.

 

You will receive the manual in your email within minutes. If you have not received an email, then probably have entered the wrong email address or your mailbox is too full. In addition, it may be that your ISP may have a maximum size for emails to receive.

Others manual(s) of Heidemann 70820 - HX ICE

Heidemann 70820 - HX ICE User Manual - German, Dutch, French, Italian - 10 pages


The manual is sent by email. Check your email

If you have not received an email with the manual within fifteen minutes, it may be that you have a entered a wrong email address or that your ISP has set a maximum size to receive email that is smaller than the size of the manual.

The email address you have provided is not correct.

Please check the email address and correct it.

Your question is posted on this page

Would you like to receive an email when new answers and questions are posted? Please enter your email address.



Info